Search results

  1. R

    Diesel to gasser

    SHADE Diesel to gas on OILBURNERS:fan:-Flame Thr-Playme
  2. R

    1991 F350 4X4 IDI Ambulance - $3,500 Atlanta Area

    My guess is pump installed wrong & starter dead. "The engine went from hard to start to will not start." $3500 not bad price & I'm a cheapskate. Nice features for a camper/hunter if lifted.
  3. R

    Is the bed supposed to look like it's flexing a lot going down rough road?

    My '86 X-Cab does the same & makes stress cracks in the bed corners
  4. R

    Rising from the grave 84 6.9 fuel issues

    Check your build date on VIN tag. May be late '84 build.
  5. R

    E3TZ-6500-A to E3CZ-6500-AA?

    E3TZ-6500-A (American) replaced by 3C3Z-6500-AA (Asian American) I HOPE NOT!! :fan:
  6. R

    Rear main seal leakage - should I use a stop leak? [1994 IDI w/ turbo]

    I would think only if you requested the replacement. TC seal should have been replaced tho.
  7. R

    Project Queso

    Just do it! Will make a difference NA or turbo. Mine is NA but torquey even with a C6:peelout
  8. R

    Talk me down off the edge, I think the engine is toast

    Pull all the rod caps off then bump the pistons to clear the crank. Remove the main caps. That crank will probably be too damaged to repair anyway. Hopefully the rod cap nuts were not that loose. You may even have damage to the base of the #8 cylinder casting. Beat the hell outta that rod
  9. R

    Found another one. 1994 f350 factory turbo.

    AMEN!!!:fan:
  10. R

    -40 winters and starting

    Does your block heater Not work??
  11. R

    ‘87 f250 6.9 small coolant leak

    STANT 10328 Lever release
  12. R

    ‘87 f250 6.9 small coolant leak

    May also just be something simple like a radiator cap. Go back with a 7lb cap. Original is 13lb.
  13. R

    Rising from the grave 84 6.9 fuel issues

    Easiest way to replace (for me) is to remove bed. 3-4 friends after you have soaked the mounting bolts and nuts under the bed/frame. Kroil if you have it handy or any good 'loose-juice'. Don't forget to unplug lights at rear bumper and disconnect both tank fill hoses from bed (3 screws each...
  14. R

    ‘87 f250 6.9 small coolant leak

    Where is the leak coming from? Front, side(s), top or rear??
  15. R

    Rising from the grave 84 6.9 fuel issues

    http://www.trexautoparts.com/categories/ford-full-size-pickup-diesel-sending-units AND WELCOME!!!!
  16. R

    variable orifice tube ?

    Cold and sweating Sounds Good!! At least you are at a point where you have cooling & can watch it. Ideal rpm to check pressures is 1500-2k. Warm weather will be back soon to check your charge. :Thumbs Up
  17. R

    Surge 5 minutes after start, advance solenoid disconnected

    Another reason I went to electric pusher pump.
  18. R

    Aft-axle fuel tank access on 85

    Use plenty of 'loose juice' before attempting to remove rusted bolts. Carriage bolts. next size larger, should work. Get some silicone grease from amazon and 'lather' the threads. Rubber fuel hose will slip over the nylon lines tightly + use hose clamps
  19. R

    Rear main seal leakage - should I use a stop leak? [1994 IDI w/ turbo]

    May be running down rear of engine. Check turbo lines and valve covers. VCs can pour from the rear. Clean & Check everything else before pulling tranny. You have a lot of oil draining down the sides/rear on pipe per your photo. Did not sling there
  20. R

    Aft-axle fuel tank access on 85

    I did the same a long time ago on my '86 4x4 in sig. Never again. I pull the bed all the time now & take care of other things that need attention while it is off. If you have an engine puller, you can make a simple frame to attach to the arm and lift it off. Otherwise get 3 other friends to...
  21. R

    Rear main seal leakage - should I use a stop leak? [1994 IDI w/ turbo]

    That's a lot of oil! If it leaks that bad, pull the tranny and replace the seal. 1st Pull that inspection cover & make sure nothing else like valve covers may be leaking & oil pan where it meets block at rear. Crank seal bad will show oil on the flywheel.
  22. R

    Cracked Cylinder? OK to drive?

    If water in the oil, you don't want to drive it. Will heat up and pressurize more water in the oil & mess up bearings. Hopefully #4 was determined by pulling glow plugs and it pumped water. May be a cracked head. Otherwise may also be an oil cooler leak and didn't want to mess with it anymore.
  23. R

    Learning about turning

    add to your favorites: https://www.nickpisca.com/diesel/
  24. R

    What is this spring thing?

    Only shows 1 in my '85 Factory Manual but all where serviced at same dealer. Maybe a dealer thing:dunno Manual shows double of same size on throttle return. Just an artist conception tho, not a photo
  25. R

    Trouble with Raylan: low oil pressure and massive blow by.

    Pull a valve cover & let it run.

Latest posts

Forum statistics

Threads
92,997
Posts
1,155,957
Members
26,579
Latest member
truckonfire

Members online

Total: 1,188 (members: 6, guests: 1,182)

Share this page

Top