Recent content by wej612
-
W
Looking for 6.9/7.3 bus/med truck engine
yeah, lot of reasons to go bus motor. My dt360 has a nice air compressor and two ac units on it. removed ac tho. The trans did have pto provisions, not sure if it could work with what you would need. only idi I have is a low mile 94 turbo truck idi. The cooling capacitu doest jump that crazy...- wej612
- Post #7
- Forum: Marketplace
-
W
Looking for 6.9/7.3 bus/med truck engine
That trans has a .7x overdrive. I can look up the number. pretty much the best medium duty synchronized manual trans out there. have the flywheel, clutch, throwout bearing etc.. everything. the out put shafts for parking break and no parking brake.. didnt dig up a complete parking brake setup...- wej612
- Post #5
- Forum: Marketplace
-
W
Looking for 6.9/7.3 bus/med truck engine
I also have an eaton fuller FSO8406A transmission. 6speed full synchronized.. comes in med. duty trucks rated to 80k gvw. Got a kid coming.. consolidating my projects! trans rebuilt resealed new synchros... good for 250k + hard miles let me know if your interested. was going to.list.. have...- wej612
- Post #4
- Forum: Marketplace
-
W
Looking for 6.9/7.3 bus/med truck engine
sae 2 bell housing idi flywheel commercial/Industrial match I think- wej612
- Post #3
- Forum: Marketplace
-
W
Looking for 6.9/7.3 bus/med truck engine
know anything about a DT360 a tiny bit bigger that 6bt, but you truck/tractor pullers run 300psi stock. makes the 6bt look brittle. I have springs to run up to 4500rpm and adapter to run a p7100 pump off a dodge.. can turn the stock pump up to more than 6.9/7.3 idi power. Let me know if that is...- wej612
- Post #2
- Forum: Marketplace
-
W
FS:1994 zf 5spd. $900 48092 MI connected to idi turbo.
Ild recommend smf and clutch to anyone who has there transmission out!- wej612
- Post #2
- Forum: Marketplace
-
W
FS:1994 zf 5spd. $900 48092 MI connected to idi turbo.
Truck ran drove great before I parted it out. with out the rust and body damage it would have beed a shame. truck went straight and stopped well! all accessories. zf5 spd $900a ttached. transmission worked great too. for sale too along with the borg warner 1356 transfer case. Buy engine, trans...- wej612
- Thread
- Replies: 4
- Forum: Marketplace
-
W
FS: 1994 7.3 idi turbo 78Kmi SE MICHIGAN 48092 $1300
Truck ran drove great before I parted it out. with out the rust and body damage it would have beed a shame. truck went straight and stopped well! all accessories. zf5 spd $900a ttached. transmission worke;Sweetd great too. for sale too along with the borg warner 1356 transfer case. Buy engine...- wej612
- Thread
- Replies: 0
- Forum: Marketplace
-
W
FS - IDI Performance
Has anyone tried a holset HX40 on a 6.9 or 7.3 idi... I have a HX40, a hy35 and a hx35 laying around... A Garrett TO4E... (41?) off a DTA360 or lower rated DT466 could work well I imagine too... I have several turbo's laying around to try out. HX40 should be good to over 400hp... very good...- wej612
- Post #77
- Forum: Marketplace
