Recent content by Sw1tchfoot

  1. S

    Clutch pedal set replacement tips or tricks?

    It may be obvious to some, but the four brake booster to clutch pedal bolts probably won't want to seperate. Leave the four nuts on (just loosened most of the way) and the brake booster rod on the pedal and push the brake pedal hard to free the two.
  2. S

    Can you use a old radiator for a Intercooler???

    I'm sure you would see some change, a decrease in fuel economy and power would probably be the main difference..
  3. S

    heater core just popped

    There are two styles, depending on factory A/C or dealer A/C and no A/C. I had no problem with my aluminum unit, I think it was a Spectra.
  4. S

    Ebay Jasper reman 6.9 and C6

    How close do the rocker arms come from hitting the valve covers with those dents?
  5. S

    TECH 101 86 down, 87-91, 92 up Std pedal assemblies!!

    So is the 87-91 assembly usable on a 1980-1986 truck?
  6. S

    P pump

    Even the VE Rotary pump on the cummins is relatively good with power and reliable. Is there not an 8 cylinder Bosch VE pump out there?
  7. S

    Air Conditioning gods needed.

    It has to be really hot for my high side pressure to go much over 300 psi. Maybe try blocking off the heater core hoses and see if it runs cooler, maybe your blend door is stuck and letting the hot air from the heater mix with the cool air?
  8. S

    Another dent on the bed facing the cab....

    I use the same lawn mower and load it in the back of my truck, I go forward until the front of the mower touches the front of the bed and push the the brake then lift up the little emergency brake lever. If you don't have it tight against the front of the bed the mower moves and the emergency...
  9. S

    TECH 101 86 down, 87-91, 92 up Std pedal assemblies!!

    Can anyone give me a quick summary of the tools I will need to grab a 1980-1986 manual pedal assembly from the junkyard? I would rather bring the minimum amount so my tools don't walk away.
  10. S

    A/C CHARGE PRESSURE

    I'm not sure if you guys mis-understood him or if i'm just stupid. When the a/c compressor is not running the pressure is the same (equalized) on both the high and low pressure sides. As the content of the system increases, the pressure increases and the pressure with 2lbs will be significantly...
  11. S

    TECH 101 86 down, 87-91, 92 up Std pedal assemblies!!

    Good info since i'm planning on converting from C6 to ZF5.
  12. S

    auto vs a stick for a diesel in heavy populated area's?

    I would rather have a car in NYC.
  13. S

    fuel cut off for engine braking

    Flipping a switch or holding a button down every hill is no benefit, it is an inconvenience. The amount of fuel injected into the engine while coasting at idle is so insignificant that such as idea is merely a safety hazzard.
  14. S

    If you think you've seen it all...

    I didn't take the picture, I found it on Reddit.
  15. S

    BILLET ALUMINUM INJECTOR CAP PART 2

    Is it feasible to disregard the rubber hoses and have aluminum connecting the caps too?
See more

Latest posts

Forum statistics

Threads
91,310
Posts
1,130,166
Members
24,121
Latest member
720Diesel

Staff online

Members online

Total: 636 (members: 11, guests: 625)

Share this page

Top