Recent content by sagebel

  1. S

    99 PSD XLT Key Fobb question

    Get in the truck and shut the door. Place key in ignition and cycle it between off and where you would turn the glow plugs on over and over. I don't remember the number of cycles that it takes but the door locks should start to lock and unlock as you cycle the key. This is when you would...
  2. S

    42.26MPG!!!!

    I'm getting about the same with my Jetta. Take that thing on a 8hr drive with the cruise set. The sad thing is that I drove a $&%^&! Prius last week while I was on travel and it only got 49mpg. Not very impressive considering vehicle cost and long term maint. Scott
  3. S

    Fuel Pressure Guage?'s

    Just got done. I put a 1/4"SAE fitting with a schraeder valve on for now until I get a good liquid filled or in-cab guage. Scott
  4. S

    Fuel Pressure Guage?'s

    I'm going to install a fuel pressure guage under the hood. I plan on using one of the ports on the back of the fuel bowl. What size fitting is it? Scott
  5. S

    Dead truck.

    None until March but then let's just say that the PCM will be marked "Return to Sender" :D I am definitely going to go to single shots and since I have the PCM I'll get that re-flashed along with a chip to match. It should make checking codes easier if needed.(oh and not to mention the...
  6. S

    Vaccume collection systems???

    55 Gallon drums will hold about 5 psi before the bottom pops and becomes dome shaped. You will know have a drum with a round bottom. Scott
  7. S

    Dead truck.

    Mike, mine is in the fuse box under the hood. It was a last resort, after the PCM didn't work I just got fustrated and started tracing circuits and testing everything. Finally got to the relay and put 12vdc on the control side and got no clicky clicky. The heater blower uses the same relay so...
  8. S

    Dead truck.

    Truck is running. It was the PCM Power Relay. Now I have a PCM just laying around. Can you say "re-flash" and "single shot"? ;Sweet Scott
  9. S

    Dead truck.

    New PCM installed, still no start. ***? Scott
  10. S

    Vaccume collection systems???

    I use a cheap barrel pump. It takes about 10 minutes of cranking to empty the 55 gallon collection drum. I didn't see any reason to spend a lot of money into something I was doing to save money. Scott
  11. S

    Dead truck.

    No fuel so no smoke. The pump is not running at all. It does operate when 12vdc is applied to it from an external source. What has me confused is there is no SES and no codes. I have PCM on the way from Jody and it will be here tomorrow afternoon. If that does not fix it I'm not sure what...
  12. S

    Dead truck.

    Here are the symtoms: Engine cranks, No voltage to: Fuel pump, GPR, and Fuel Heater Relay. All fuses are good. No wait to start light, SES, or Tach movement. I have changed the CPS. Batteries are less than a year old. Chip has been pulled. Any ideas? Scott
  13. S

    We tried our first batch.....

    Darling is up here too. I noticed that when I picked up on Saturday that their dumpster was gone. The bar and grill canceled their service 4 months ago. I look at it this way: If I can LEGALLY haul a 55 gallon drum of methanol in the back of my truck, than there is no problem hauling 55...
  14. S

    Sources for materials

    Daryl & Scott, where are you guys getting your methanol and how much are you paying? Scott
  15. S

    We tried our first batch.....

    I'm using KOH. I just asked them how much more it would cost them for the rendering service to pick it up vice me picking it up and them changing their oil more frequently. Scott
See more

Latest posts

Forum statistics

Threads
91,324
Posts
1,130,346
Members
24,130
Latest member
JFMac

Members online

Total: 594 (members: 9, guests: 585)

Share this page

Top