onetonjohn's latest activity
-
onetonjohn replied to the thread Doing oil cooler. Is this trick legit?.Noticed the head gasket is seeping in the front drivers side. I really don't want to pull the head off right now. Can it run like that... -
onetonjohn replied to the thread Clinking( metal clicking) noise when rolling.If you add your truck details in your signature, it will help us figure out what you've got. If you have extended cab truck, your rear...
-
onetonjohn replied to the thread Doing oil cooler. Is this trick legit?.Exhaust bolts came right out. Way easier with manifold gone. Thanks for the tip. Need to go get exhaust gasket and radiator hose...
-
onetonjohn replied to the thread Doing oil cooler. Is this trick legit?.I'm afraid to touch the exaust manifold bolts (probably rusted together over 40 years). I suppose I could try to crack them loose, and...
-
onetonjohn replied to the thread Doing oil cooler. Is this trick legit?.Hadn't fully considered what that meant going in. I was thinking I would get it out, then pull the front off and clean and assemble in...
-
Found this: https://www.oilburners.net/threads/oil-cooler-rebuild-for-dummies.20121/#post-228845 Talks about unbolting the back and...
-
-
onetonjohn replied to the thread Sudden air intrusion.I had debris clog the line after working for some time. kinda luck of the draw if the little floaty or sinky bits get sucked into the...
-
onetonjohn replied to the thread Sudden air intrusion.Does the switch work? Maybe you're still pulling from the (empty) tank. If that's fine, I'd check the water separator - maybe bypass...
-
onetonjohn replied to the thread Hesitates after start (600RPMish) for 3 seconds - then runs normally.The white smoke... Retarded timing? I haven't timed it yet. Could that affect initial RPM? RPM issue from low fuel pressure from...
-
onetonjohn replied to the thread Hesitates after start (600RPMish) for 3 seconds - then runs normally.That's what was happening before I fixed all leaks in the return system. Very annoying and kinda PITA to get all the leaks (took...
-
onetonjohn replied to the thread Hesitates after start (600RPMish) for 3 seconds - then runs normally.Before injection pump - draining fuel from the filter? The return line system is tight. I can check the filter is still full before I...
-
onetonjohn replied to the thread Hesitates after start (600RPMish) for 3 seconds - then runs normally.Got a chance to try it. Push to floor and start. Brown truck fires right up at high Idle. White one (the one I'm working the bugs out...
-
onetonjohn replied to the thread Hesitates after start (600RPMish) for 3 seconds - then runs normally.I'll try it this weekend. Hopefully I'll get some time with my trucks.
-
onetonjohn replied to the thread Hesitates after start (600RPMish) for 3 seconds - then runs normally.I think so, but I don't normally push pedal to the floor to set it. Should I be doing that before I start it?
-
onetonjohn replied to the thread Hesitates after start (600RPMish) for 3 seconds - then runs normally.Didn't look. I know the return lines are leakproof. Fires right up after sitting for weeks.
