Recent content by Ggg

  1. G

    Any 4bt's out there?

    Look into Dovebid, they auction off a lot of P30 style step vans with diesel engines. But before buying an engine figure out what drivetrain you will have. This may make a difference in what engine to trans adapters you want to look for. I have a 4bt in a Jeep TJ, my engine came from a van...
  2. G

    Odd CDL question.

    My auto ins. actually went down due to the CDL because they consider you a better driver or at least better trained driver. I can't remember how much I saved but it was not much at all.
  3. G

    Odd CDL question.

    The fee for license renewal is double what a regular one is, and if you have Haz Mat endorsement you are mandatory for written testing every time, and background checks. I have not had my physical card current in 10 years but no longer drive commercially so there is no need for it. I need to...
  4. G

    Brake Problems

    Your slides may be damaged from being bound up for so long. Check to be certain there is no worn areas that could put the caliper in a bind when braking. They might slide just fine with no braking force applied but bind up when braking forces are applied to the caliper.
  5. G

    E-350 Bogging down an loss of RPM

    Where are you located, and what is the ambient temps? When was the last time the fuel filter was changed? Any change in fuel supply?
  6. G

    '01 IH 4700 w/ T444E - Where is the...???

    Aaron is right it is just above the oil filter on the left side of the block. Yes it is entirely possible that the truck does not have a block heater. It is an option, some times people don't choose it when specing out a new truck.
  7. G

    6.9 identification

    Is there any reliable way to identify a 6.9 from a 7.3 by looking at it in the truck?
  8. G

    E40D problems

    I see you have a TS chip, I had one too and I did not care or the trans shift programming especially after the BTS was installed. Long story short I ended up getting a DP Tuner chip and I like Jodi's programs better, as well as the trans shifts how and where I like it. So my point is you might...
  9. G

    E40D problems

    It sure is nice when you lay that kind of jack down and get more then you expected. ;Sweet
  10. G

    E40D problems

    Glad we all could help. IIRC the stock Ford donuts are not the best to use. I remember that GM makes some that are thicker and thus tighter fitting and are graphite impregnated so they move with the pipes better then the white Ford donuts. But I can't remember the part #.
  11. G

    E40D problems

    Torque converters do not bolt up to the trans at all, they just silp into the pump drive. So be careful not to tilt the trans while installing it otherwise the converter will just slide right out. The torque converter bolts up to your flex plate on the engine. . Good point 94f450sd while the...
  12. G

    E40D problems

    The stock converter does use nuts. My BTS converter needed bolts so I would assume an ATS one would too. Locltite would be a good idea too. Yes there is a gasket for the t-case about $6 at Ford. I recommend Schaffers trans fluid if ATS does not specify one. Start now by spraying the selector...
  13. G

    E40D problems

    My best guess is that a Ford tech will do a stock rebuild. There are quite a few hard part upgrades that can be done to improve on the factory setup that are not offered through Ford
  14. G

    Questions about / need a gear driven PS pump...

    When I got my truck the PS pump was missing. I found one on e-bay for about $60, granted it did need a seal kit but still a lot cheaper then the parts store.
  15. G

    need advice for more power on 99 7.3

    Gages first, Tony Wildman or DP tuner chip, 4" exhaust, Tymar intake, (I do not like K&N on any turbo diesel). BTS trans, either a GT38, H2e, or Black widdow performance turbo, BDP injectors, Big oil, aftermarket rods. By now you will have a thin wallet.
See more

Latest posts

Forum statistics

Threads
91,292
Posts
1,129,832
Members
24,106
Latest member
lewisstevey7

Members online

Total: 658 (members: 4, guests: 654)

Share this page

Top