I now have 3K miles on WMO mixture and have backed off on the gasoline in the mix and taken it to about 30-40% WMO and one can of PS (silver jug) and the rest #2 and it is much better with the smoke. I recently added bigger tires so I had to turn up my programmer and that may account for the...
Thanks for the info and I will cut the mixture back and run some cleaner through there. Any recommendation on what cleaner works best? I plan on making some trips soon that can run this stuff through the lines.
I only used 110 gallons of WMO in a tank of 275 gallons. I guess I need to poay attention to where I am drawing from in the tank. Maybe that stuff settled and my pump pickup may have been too far on the bottom. I know the 3rd Gen is pricey to fix but I dont mind living on the edge. If I ruin...
I am over 1000 miles on the mixture but man the smoke is bad. I did order the specific gravity teter and will put it to use but the mix is in the truck and I have to keep rolling with it until it gets here. Any help on reducing the smoke, other than installing a water injection kit?
I am up to about 350 miles on my mixture and the only complaint that I have is the smoke. Even at idle it is fairly bad. I guess I need to add more gasoline. I only put in about 20 gallons into a batch of 275 or so gallons so maybe I should take it up to 20%. Does anyone know the make ratio for...
I am not saying you are wrong but I am hoping that the amount I poured into a 250 gallon tank is not going to make that much of a difference. I sure hope I dont have any problems since this is my daily driver and work truck. I also have heard that WMO will not work in a 3rd Gen truck either and...
I just mixed up my first big batch of WMO and for use in my 04 CR. I do have a FASS system with a Baldwin filiter that goes down to 1 Micron. I used a 250 gallon farm tank in an enclosed trailer and put in 110 gallons of waste motor oil, filtering through a 10 micron fuel filter then added 20...
I have an early 04 without a cat and plan on setting up a pump/filter/waterseperator to make multiple passes on the WMO mix before it is put into the truck. Once it is put in the truck it will be passed through a FASS with a 1 micron filter.
I thought that anything below 5 micron was safe...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.