I have 4 35/15.5/16.5 BF Goodrich MT, 2 have a few miles left and the other 2 are iffy. I will take some pics if interested. I also have a set of 39.5/16/15 TSL swampers with ZERO miles on them. I have a 01 PSD so I have no use for any IDI stuff anymore.
For the whole setup or just the replacement cartrages? I paid 40 bucks for the housing and two filters. Not too bad IMO. Ace hardware wanted 38 just for the housing and 7 for each filter.
I am using a 12 volt Fleabay special, It pumps though its just slow. I thinned it out with 50/50 WMO/diesel and and it pumped alot faster. Do yall think I should thin it out some more? I will be running it in a 2001 PSD.
I have just finished my WMO filter setup and I noticed that its way too think to filter with a 10 micron and a 1 micron water filter when its strait motor oil. I was going to filter down about 30 gallons or so and blend around 5 gallons varius ways until I had it right but its taking forever to...
Magnaflux and hot tank crank block rods and heads $95
Grind crank $85 or polish is $45
Work heads using old valves with new seals and 1 angle valve job $350
Press rods $45
Bore out 8 cylinders $125
Shot peen rods $60
Freeze plugs and cam bearings install $45
Thats what it run me on my...
Got her back yesterday, I hava a quadzilla chip, elcheapo intake with a huge filter from Flea bay and a 4" moto blue exhaust turbo back system on the way. I also have a set of guages and a piller pod coming aswell. I got the quadzilla because it was used and cheep but I will save my pennies and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.