DirtyWood's latest activity
-
DDirtyWood replied to the thread New 3g alternator--High voltage and then low voltage, bad regulator?.How is the 1g alt grounded? The 1g setup works very well at the moment and the E4OD doesn't complain so I think the wiring is in decent...
-
DDirtyWood replied to the thread New 3g alternator--High voltage and then low voltage, bad regulator?.The alternator should ground through the brackets. I've done the 3g conversion on another truck and did not need a separate ground...
-
DDirtyWood replied to the thread New 3g alternator--High voltage and then low voltage, bad regulator?.Wiring is solid. No open circuits. There's not much to check with these 3g alts. I double checked the 3g connector and it's good...
-
DDirtyWood posted the thread New 3g alternator--High voltage and then low voltage, bad regulator? in 6.9L IH & 7.3L IDI Diesels.Installed the new alternator and double checked the new wiring before starting the engine. First start the voltage slowly climbed up to...
-
DDirtyWood replied to the thread Facet pump problem?.I had some performance issues with the facet pump but was able to increase the fuel pressure about 1-2 psi simply by blowing out the...
-
DDirtyWood replied to the thread Coolant filter kit.There are "as needed" coolant filters charged with SCA. I think one company is Penray and supposedly the filter only releases SCA...
-
DDirtyWood reacted to IDIBRONCO's post in the thread Samco Sport Silicone Radiator Hose Reviews with
Like.
I, for one, haven't been tempted to spend $300+ on a couple of radiator hoses. -
DDirtyWood replied to the thread Coolant filter kit.If the pink coolant you're using is Fleet Charge it will be a while before you need to use a charged filter to add SCA content. I can't...
-
DDirtyWood replied to the thread 3g alternator conversion--pulley problem..I used the orange Loc-Tite since I've never had it fail on me but it's still way easier to remove than the red stuff. It would've been...
-
DIf you're using locktite you should be fine, IF you're really worried get a small set screw ( allen head) and tap the interphase of...
-
DDirtyWood replied to the thread 3g alternator conversion--pulley problem..Found the smaller v-belt pulley and thought I'd post it, https://store.alternatorparts.com/partno242105.aspx 73mm OD instead of 85mm...
-
DDirtyWood replied to the thread 3g alternator conversion--pulley problem..Well that's exactly what mine looks like after assembly. I guess it's Loc-Tite to make it all-right. Or find another pulley. I've...
-
DDirtyWood reacted to Jesus Freak's post in the thread 3g alternator conversion--pulley problem. with Like.
Mine survives without a lock washer..... but im a nut.....
-
DDirtyWood posted the thread 3g alternator conversion--pulley problem. in 6.9L IH & 7.3L IDI Diesels.Finally getting around to the 3g upgrade but have an issue or potential issue with swapping the pulley over. I have a new Bosch AL...
-
DDirtyWood replied to the thread Holley Red are garbage, what else quickly?.Too bad about the Holley Reds. Were they all purchased from the same source or multiple sources? I'm not trying to revive a debate but...
