DirtyWood's latest activity
-
DDirtyWood replied to the thread Best Valley Pan Gasket?.CDD just buys and resells the Fel-Pro intake gasket and they are still cheaper than most places. They can be reused though. I found an...
-
DLooking for two decent condition manual gooseneck side mirrors--the 7.5"x10.5" ones. I don't need the brackets but just need the mirror...
-
DDirtyWood replied to the thread Battery jumper packs?.The peak amp ratings for ALL those jump-packs seem to be essentially false. They may technically be able to hit very high amperage for...
-
DDirtyWood replied to the thread Starting and Trans issues after removing ambulance box.You have an E4OD and you 100% need a functioning tachometer. The E4OD also needs incandescent brake lights or if you went LED then you...
-
DDirtyWood replied to the thread Donaldson DBL7405 oil filter on a 7.3idi.17qts of synthetic sounds a little expensive but nice to know your sample came back okay after 8k. I only drive about 9k-10k per year...
-
DDirtyWood replied to the thread Can I install a kill switch on my truck?.Maybe just disconnect the factory connector at the IP and wire in a new circuit tied to a switch tucked under the dash? By creating a...
-
DDirtyWood reacted to Brian VT's post in the thread Can I install a kill switch on my truck? with
Like.
Seems like it'd be simple enough to wire in a switch to prevent the fuel safety shutoff valve from opening (which happens when you turn... -
DDirtyWood replied to the thread CDD injection line issues.If you do get the whole set of lines you should be aware that more than a couple people have had difficulty timing the injection pump...
-
DDirtyWood replied to the thread Donaldson DBL7405 oil filter on a 7.3idi.I'm curious which oil you were running.
-
DDirtyWood reacted to BrianX128's post in the thread Donaldson DBL7405 oil filter on a 7.3idi with Like.
I remote mounted one on my truck, I also have a bypass filter. Up to 17qt capacity overall and oil was still really good at 8000 miles...
-
DDirtyWood replied to the thread Donaldson DBL7405 oil filter on a 7.3idi.I ran one for a while on a 1992 4x4 F250 and I had to do a little grinding to nake it fit. The DBL7405 used to be only $20 at...
-
DDirtyWood reacted to Nero's post in the thread Anybody try converting their RD-80 to an RD-90? with Like.
That is a graphite composite head gasket. The originals were stamped steel with sealant on them.
-
DDirtyWood replied to the thread Anybody try converting their RD-80 to an RD-90?.Composite head gasket? I used Fel-Pro Permatorque blue gaskets.
-
DDirtyWood reacted to Nero's post in the thread Anybody try converting their RD-80 to an RD-90? with Like.
You only need to worry about studs if you start pushing over 12psi boost. You can turn it up, and trial and error it to find the sweet...
-
DDirtyWood posted the thread Anybody try converting their RD-80 to an RD-90? in 6.9L IH & 7.3L IDI Diesels.I've been running the RD-80 for a few weeks and like it a lot, but of course there is the temptation to convert it to an RD-90 using the...
