6.9 Superduty
- Thread starter Mikey89014
- Start date
Mikey89014
Full Access Member
You must be registered for see images attach
Just built these ..they are made out of one and a half inch angle iron into quarter inch thick steel plates.. the crossmember I did not have to modify.. I might have to shorten the driveshaft maybe we will see.. has a little bit of movement but maybe not enough..
I made custom radiator mounts as well for an aluminum IDI 2 row Champion.. Will post those soon too.
Last edited:
pastorjeep
Full Access Member
Attachment error?
Mikey89014
Full Access Member
Hows that?
pastorjeep
Full Access Member
Mikey89014
Full Access Member
You must be registered for see images attach
Heres a pic of motor mounts installed and underneath .
You must be registered for see images attach
You must be registered for see images attach
Last edited:
Mikey89014
Full Access Member
You must be registered for see images attach
You must be registered for see images attach
Radiator , shroud and IDI fan installed
Last edited:
Mikey89014
Full Access Member
Getting ready to fire it up for ths first time ..
pastorjeep
Full Access Member
Looking great! Can you explain how much od the factory IDI mounts you used with your fabricated mounts and how you tied them into existing? frame holes.
Mikey89014
Full Access Member
Anyway all , it runs . Will post vids shortly. Yay!!
junk
Full Access Member
Awesome! Glad to hear it. Looking good. Thanks for keeping us updated.
Mikey89014
Full Access Member
I used the factory mounts , then fabricated those other mounts that add to them. They basically raise the engine 1.5 inches and forward from the original frame holes by 2 inches . Requiring no mods to frame or original motor mounts . They are basically sandwiched between frame and original mounts..
Last edited:
Mikey89014
Full Access Member
My vid is 455 mb and hard to post. Anyone have an idea how?
post onto Google drive and link to it.
Mikey89014
Full Access Member
ok trying now
