Recent content by 88IDITurbo

  1. 88IDITurbo

    Steering Shaft Upgrade Time

    I installed one with the vibration dampener. Very pleased with the results and improved response. Well made part and worth the coin $.
  2. 88IDITurbo

    Steering box!?

    I have a steering box out of my 88' if anyone is interested.
  3. 88IDITurbo

    Offical IDI RALLY Parts For Sale and Wanted thread.

    No I will not be coming to the rally so if they do not sell please let me know!
  4. 88IDITurbo

    Offical IDI RALLY Parts For Sale and Wanted thread.

    Do you still have the $20 core injectors? if so please PM me I am interested.
  5. 88IDITurbo

    Temperature Sender / Sensor

    Thanks for the info Heath. Do you or anyone else know the part number for the over-temp sensor? (dummy light)
  6. 88IDITurbo

    Temperature Sender / Sensor

    do you use an aftermarket gauge with the aftermarket sender or do you use the aftermarket sender hooked to the factory gauge?
  7. 88IDITurbo

    Temperature Sender / Sensor

    OK I found the part number for the high idle, cold start sensor. Motorcraft E8TZ9E939A. Now I just need the number for the overtemp sensor or the NAPA version that Mel recommended for running a cooler overtemp sensor.
  8. 88IDITurbo

    Temperature Sender / Sensor

    Mel, from I can tell the SW2520 is the real time temperature switch located on the drivers side head closest to the firewall. Do you or anyone else know the Motorcraft part numbers for the other two sensors? Overtemp sender and High Idle?
  9. 88IDITurbo

    Temperature Sender / Sensor

    does anyone know part numbers for each sensor?
  10. 88IDITurbo

    Temperature Sender / Sensor

    From what I have gathered there are 3 different coolant temperature sensors on these engines. Can anyone tell me what the part numbers are for these different sensors? I am looking on rock auto and only see the 1 coolant temperature sensor MOTORCRAFT Part # SW2520.
  11. 88IDITurbo

    Dana 60 Alignment

    Were is that measured from? And is that each side or total?
  12. 88IDITurbo

    Dana 60 Alignment

    I am looking for the factory alignment specs for a Dana 60. I went through my truck and replaced all the steering with new steering box from PSC tapped for hydro-assist, Borgeson steering shaft, and Ballistic Fabrication hi-steer kit and now need to get everything re-aligned. I have my...
  13. 88IDITurbo

    Flatlander build piston solution found

    Subscribed!
  14. 88IDITurbo

    89 CC build thread Frame off resto!! - Bad Idea

    I like the interior color combo! Who will be recovering your seats? Someone local or are you sending them out? I would like to have my bench seats recovered in a leather or leather like material and am just curious.
  15. 88IDITurbo

    arp headstuds

    Thanks! I want to remove the heads completely as you have shown, to install the studs. If that cannot be done with the engine in the truck then I guess I will have to pull it. May try to do a few other things while the engine is out. :sly
See more

Latest posts

Forum statistics

Threads
91,344
Posts
1,130,707
Members
24,143
Latest member
Cv axle

Members online

Total: 157 (members: 2, guests: 155)

Share this page

Top