Dana 60 Alignment

[88IDITurbo]

I am looking for the factory alignment specs for a Dana 60.

I went through my truck and replaced all the steering with new steering box from PSC tapped for hydro-assist, Borgeson steering shaft, and Ballistic Fabrication hi-steer kit and now need to get everything re-aligned.

I have my steering wheel and box centered and now need to set the proper toe alignment so I can determine my draglink and tie rod measurements.

Any help is appreciated, I searched in the tech section but couldn't find any other threads about this.

 

[Iowa 73]

1/32 inch IN preferred
Min 3/32 inch OUT
Max 5/32 IN

 

[88IDITurbo]

Were is that measured from? And is that each side or total?

 

[Iowa 73]

Google measuring toe in. The setting refers to the difference between the measurement at the front of the wheel vs. the rear.