Search results
-
J
Refrigerant leak around this valve?
You can replace the schrader with the system charged by using this https://www.amazon.com/MASTERCOOL-81490-R134a-Remover-Installer/dp/B000KITSMI- Jubjub
- Post #6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
J
My arduino gauge project
I had forgotten about my own thread. I got busy and put this project on the back burner. I did get the fuel pressure transducer hooked up to my diesel ranger, but the readings bounced all over the place. Could be a bad connection. Good to know about the sensors you are using. I'll have to...- Jubjub
- Post #36
- Forum: 6.9L IH & 7.3L IDI Diesels
-
J
My arduino gauge project
Yes, right now it is just a simple 16 character 2 line LCD display, but i'd like to use a higher resolution touchscreen lcd later so it can have graphs and gauges Woosh, that went over my head. Gotta lot more reading and learning to do. So looks like a variable reluctance sensor is similar...- Jubjub
- Post #5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
J
My arduino gauge project
Just started tinkering and though a good first project would be to get more instrumentation for my 91' e350 based RV. First thing was fuel pressure. I was going to do pre and post filter to see when it needed to be changed, but i'll only have 5 inputs with this design so i think i'll just do...- Jubjub
- Thread
- Replies: 67
- Forum: 6.9L IH & 7.3L IDI Diesels
-
J
MLPS wiring help
Rewired it all to original configuration (2nd from bottom) and it starts now. Question is, what is the bottom diagram for?- Jubjub
- Post #2
- Forum: 6.9L IH & 7.3L IDI Diesels
-
J
MLPS wiring help
Trying to replace it on my 1991 E350. Used this diagram to repin it, now I have no start. Only thing odd I noticed was pin 6 on the old connector labeled Trans range sensor. It is a white with red stripe. I went ahead and put to pin 7 on the new one. I've seen some people say it doesn't...- Jubjub
- Thread
- Replies: 1
- Forum: 6.9L IH & 7.3L IDI Diesels
