Search results

  1. O

    Goldie.... Burried alive! She rebels!

    Hey Ron up here during snow season i always carry 12 sand bags and 2-8ft sections of custom traction boards along with tire chains. My boards are 2-- 1/2" OSB 3ft wide, 8ft lengths joined together, with alternating 3/4" and 1/2" x 1" strips of lumber, 6" apart. Saved me and fellow locals...
  2. O

    Fuel pump bypass? or block off plate?

    dont get one with a big BOWTIE on it though!!!
  3. O

    batteries

    i use wally yellows too, up here in alaska, but the extreme cold kind of wears them down quick(about -30 to -40F) without the cold i have had no problems. If my truck wont start without plugging in then i just return them, but whens its that cold i only start/stop at my house anyways. So i...
  4. O

    towing question

    thank you everyone for your advice. The only setback i had was trying to figure out that there are 2 adapters for a 7pin to a 6 pin(the center pin is either brake or aux). Did the whole runaround thing and got my old kelsey brake controller tested at the same place were i bought my ball and...
  5. O

    towing question

    yeah tom i have a ball that is rated at 12k along with a new ball mount that is also rated at 12k, and the things alone probably weigh 50lbs. It is just one of those things were you have to use what you got to make things work on a budget, and have to get done. I will feel alot more safer...
  6. O

    towing question

    holy cow joe!!! that is some serious weight. I am convinced to go with the frame mounted hitch. Thanks Mel what happened to the moose truck in 97?
  7. O

    towing question

    Saturday i am gonna haul a t200 bobcat with a brush cutter attachement and bucket up to our cabin about 80 miles north of were i live. The rental place said about 12-13,000 lbs. There wont be much hills on the way other than small foothills, but i have a class V hitch that is rated at 8,000...
  8. O

    3.08 or 3.55

    the way i see these trucks are most equivalent to the mastercard commercials, we may spend $80 on GPs, $300 on a IP, and staying on the road PRICELESS! To add on to the "priceless" is way better than more costly parts, and far less expensive vehicle to drive all around than todays modern...
  9. O

    funky guages ?s

    thanks for the respsonses guys, i have the pyro mounted(Autometer Sport Comp) at the top and the trans temp mounted middle and now i have the bottom one open until my oil pressure guage comes in. Would having the trans temp send line runing close to the pyro wires cause enough of a disturbance...
  10. O

    funky guages ?s

    i just modified a 92 and up A-pillar to make room for more guages and added a tans temp guage. For the most part my Trans temp guage is working right, except one time it started rising until it read 250 going down the highway unloaded and i knew it wasnt right, pulled off the road and let the...
  11. O

    GP controller?

    i want to keep a user friendly version start-up with no ill effects for my brothers and father who will be using my truck when i leave for boot camp (BC) this fall and want them to use the truck and haul with it, so i want to keep the ford solid state GP system and just make sure everything will...
  12. O

    DUDE!DIESEL POWER MAGAZINE HEADS UP

    w/ everyone else!! it is always greatful to hear about these old trucks and how many are on the road today and still working, talk about stubborn to retire!!! Just got done hauling my lil bros 91 explorer on a near 2,000lbs trailer about 55 miles to a buds shop and i was actually passing old...
  13. O

    GP controller?

    how can one go about doing a resistance test? Electricity has never really sparked my interest into learning more about it, but do i run it pretty much like a continuity test where i run off the positive-positive lead and touch the ground lead to the GP?
  14. O

    GP controller?

    i have motorcrafts in and the GPs were changed when i bought the truck 3 years and about 34,000 miles ago. I have been working construction in a remote site in alaska since May and came back this month and it was starting to act up and not make em click and the truck was fine before i left. It...
  15. O

    GP controller?

    Cold starts in the morning are a pain, my WTS light stays on for about 12-14 seconds and it is getting to the upper 40s here at night and i just tested all of my GPs with a test light for continuity and all checked ok. I think i have the proper burn time, but after the WTS light goes off there...
  16. O

    Top end work????s

    cool i was thinkin i could do that, just wasnt sure. Yeah i am gonna borrow a cherry picker or take it to my friends house and do the work their.
  17. O

    Top end work????s

    well seems that my valve guides are deff on their way out and i will be pulling the heads and sent to a machine shop very quickly. My question is there any precautions i should take disassembling the AC unit? More notably the compressor so i can pull the driver side head more easily, also if...
  18. O

    What oil?

    i run delo, what most the commercial fishing fleet uses in medium-heavy duty diesel engines up here in alaska. My skipper in my greenhorn year swore by it and his father was a SeaBee in the navy way back in WWII era and also learned heavy equipment mechanics and that is what he uses in his...
  19. O

    Right bank white smoke

    i dont know, just throwing another possibility out, is the IP off by 180* has it been timed, says you swapped IP
  20. O

    Electric fuel pump

    okie on TDS has a wiring schematic in his sig
  21. O

    A-Pillar?

    cool, thanks, i have been working out of town since june and just got back and finally have some $$$ for my truck. Trans temp should be here soon, and eventually a turbo and boost guage. How do most people stack there guages, i was thinking (top to bottom) boost, pyro, trans temp?
  22. O

    A-Pillar?

    Does autometer make a triple A-pillar guage pod for a 91? Or can a 92-97 triple pod be modified for a 91? TIA --Ryan
  23. O

    E4OD & Banks Transcommand really hard shift

    check the FIPL, there's an excellent article in the subforum.
  24. O

    kelsey trailer brake

    i have an old kelsey trailer brake controller that i am trying to dial in right now, before a bobcat tow in a couple weeks. I just got done cleaning all the connections and everything cause i wasnt getting power to it. After mopping all the connections it works fine, at least it functions and...
  25. O

    Stage 1 installed

    an easy one is since you have free flowing exhaust listen to the tailpipe and listen for a chuff chuff chuff, or remove the intake filter housing and listen for a woof woof woof sound, both while the engine is running. Tailpipe chuff sounds will narrow it down to exhaust valvetrain or the...

Latest posts

Forum statistics

Threads
91,333
Posts
1,130,557
Members
24,137
Latest member
m2rtin

Members online

No members online now.
Total: 688 (members: 1, guests: 687)

Share this page

Top