Sounds like idle romp.
Do you have a scanner? It will help to see the problem.
If not. Unplug the EOT before the cold start. See if the romp changes. Also check the IPR connection. (corrode/oil).
Bill
Maybe the psi is input signal and the HZ would be the output side of the mapp. It converts psi to HZ.
Or bad wire back to pcm (hz sig out).
Sounds like pcm is useing limp for the signal.
Just a wag.
Bill
Have 100pcs. of the 75.0K resistors used for the IDM voltage upgrade to 140volt. These are for the IDM-100 or 110. Get one to your house for about a buck for the shipping. If you need or just want one.
E-mail me at [email protected]
BILL
Do a line pressure test. Pull the plug on drivers side of trans its just above the pan foward of the control of trans. Install a press gauge.
Spec.
Line Pressure Idle
p,n=50-65psi
r=70-100psi
d,2=50-65psi
1=70-100psi
Test with trans up to temp.
Total pressure tests 6.
Post your...
The one i have is from Garrett 1.00AR. Banks has them but wants way to much for them!!!. I did a search on the net for turbo repair kits ect. I paid 150.00 for it while banks wanted 400.00 for the same house. I have seen them on e-bay. As far as the .84ar they seem to work well in the wastegated...
In 97 stock was a 1.15ar non waste gate.
I run 1.00ar. Has quicker spool with chip. Boost starts to build off idle.
I would like to try the .84ar but i think it would start to build to much exhaust pressure at high rpm.
BILL
Do you have to test SCA levels in the 24valve motor? :confused:
Is it known to have cavation in the cooling system?
Thanks this is for a 02. ;Sweet
BILL
From what i have found. E-series vans, Cal F-series, All have split shot inj with higher pressure reg. So if you have either you allready have the mod. I would say the mod is safe (it comes from the factory). Only diff is you will use mod with single shot inj.
BILL
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.