Search results
-
C
Suspect IDM issue
94.5 body, idm110, mle1 pcm 7.3, zf5, 4x4 Truck will rev out in neutral; but no power to accelerate; will idle up to speed if you let it. FORScan buzz test says injectors 5/7 high to low issue. So I moved the 1/3 pigtail to 5/7 and vice versa; still says 5/7 issue. If the 5 pin uvch connector...- cragenj3
- Thread
- Replies: 3
- Forum: 7.3L Powerstroke Diesels
-
C
Losing prime at fuel bowl, 97 7.3
It's a 94.5 body; I think it's a 97 engine; it's a 97 computer at least. So...it takes forever to start; literally like 10 seconds of cranking. No fuel under it. I'm losing fuel bowl prime. I was going to just live with it, but I've also got no power under load; I can idle down the road in...- cragenj3
- Thread
- Replies: 1
- Forum: 7.3L Powerstroke Diesels
-
C
Broken sensor near HPOP
AI said it's the ICP...but all the diagrams I can find show the ICP is in the valley at the front of the drivers side head. Its just backward of the EOT sensor; on the bottom side it's like it's threaded into a 3/8 brass pipe that goes down behind sight. Wires are gray w/red, brown w/white...- cragenj3
- Thread
- Replies: 3
- Forum: 7.3L Powerstroke Diesels
-
C
Tail light voltage drop
1992 f250 supercab long bed 2wd 7.3, manual I haven't compared this number to my front turns but my rear turns only have 6v in the socket or at any point in the wiring, down the frame, up until it reaches the front of the cab, where I stopped following it..because it doesn't seem to matter...- cragenj3
- Thread
- Replies: 19
- Forum: 6.9L IH & 7.3L IDI Diesels
-
C
92 IDI fon electrical..
Has the extended cab So my brake/haz/turn work I've got 3 wires, though I don't remember the hot wire color so I'll just call it hot...I wanna say it's pink or yellow. Brown, black, and hot to the rear pass tail bulb (3157) I didn't check volts in any state other than running lights on...- cragenj3
- Thread
- Replies: 4
- Forum: 6.9L IH & 7.3L IDI Diesels
-
C
92 f250 idi - i beam lift? 2wd...
1992 f250 idi, 2wd... So the front you can only get 2 or 3" before your steering knuckle starts pinching, even with new camber bushings... So you've got to drop the ibeams to keep lifting, but I can't find any drop brackets for the 2wd. I ordered some 4wd brackets from eBay but they didnt fit...- cragenj3
- Thread
- Replies: 10
- Forum: General, Performance, Upgrades & Accessories
-
C
Still need ideas 7.3 idi air intrusion
Odo says 218k title says exempt Dual tanks; new TSV, new hose everywhere. New return caps, fuel filter, 1-3psi epump Clear hose between epump and filter. Fuel ratedTeflon on filter housing inlet and outlet, Schrader, capped return, and sensor.... Capped driver's front injector cap. All new...- cragenj3
- Thread
- Replies: 8
- Forum: 911 Diesel Down!
-
C
7.3 idi fuel filter light but worse
Fuel filter light came on; truck died pretty quickly after. On the road, so took it off dumped it put it back on, primed it, tried to go. Nada. Ran the batteries dead. So I got a tow and a pull strat; took 2 pull starts to start and ran rough, some injectors popping, heavy whitish smoke...- cragenj3
- Thread
- Replies: 34
- Forum: 911 Diesel Down!
