Search results

  1. R

    Oil Cooler Rebuild

    Hey guys Been reading up on oil cooler rebuilds - mine recently developed a leak (leaking oil to the ground on the rear end cap - suspected failed o ring). With my tools and space I am not prepared to pull the engine. I found the diesel hub had a decent write up on removal and rebuild by...
  2. R

    ZF5 Lubricant

    Hey guys Recently got a rebuilt ZF5 installed with a new south bend clutch. Noticed some new noise in the low RPMs 1000-1200, 2&3rd gear(literally only 20 miles on it so far). After driving home thinking about it I remember someone on here saying they were using a heavier oil on their ZF5 and it...
  3. R

    Hooking up the waste gate to a vacuum source

    Hey All So today was my first day driving my truck with a turbo kit installed. 92 F250, CDD stage 2 kit, R&D factory NA pump turned up 4 flats, R&D injectors. On flat roads unloaded I got up to 9-10 PSI. I’m totally happy with that but was reading about others who mechanically bound the waste...
  4. R

    Oil Pressure Sending Unit Removal - 7.3 NA

    Didn’t see a thread close to what I was looking for - hope it’s not a duplicate. I just started a CDD / 093 turbo kit install. Planning to remove the factory sensor, put a tee on it and then put the factory sensor back in the same general location. Question, is there a hex on the oil pressure...
  5. R

    V Belt Pulley List - 7.3

    So i did some light searching and didn't see a thread that was exactly what I was looking for. I am looking to start a thread with part numbers and currently available options for the V Belt Pulleys for the 7.3. Currently I am searching for a 7.3 water pump pulley, 3 groove. From other threads...
  6. R

    Hypermax Exhaust

    Anybody running a hypermax exhaust kit? I recently ordered a stage 2 kit from CDD for my truck and I was looking at the Hypermax 3.5" and 4" exhaust kits. The website says the 4" is for the PSD, but I was figuring since its the same body, the exhaust should be really close and would probably...
  7. R

    What is this bracket for?

    Any body know what this bracket is for?
  8. R

    Timing related to cold starts

    Hey all Looking for some input from the experience on this forum. Could the timing affect cold starting? I presume that it could and I would guess advancing the timing would make it easier to start, hence the cold idle advance solenoid. Can anyone confirm this? Has any one seen any difference in...
  9. R

    Valley pan removal

    I didn’t see a thread on this, but hoping to draw from the knowledge on this forum. I bough my first turbo kit and I’m getting ready to install it. I purchased a new valley pan / gasket with the kit and I was wondering - does the IP need to be removed to replace the valley pan or can you get...

Latest posts

Forum statistics

Threads
93,000
Posts
1,155,990
Members
26,589
Latest member
tke395

Members online

Total: 666 (members: 5, guests: 661)

Share this page

Top