Search results

  1. R

    Did my IP finally fail

    If you have a place to get some Hot Shot Winter anti-gel, put some in your fuel filter and the rest in your tank(s). Let it idle for a while. Should take care of that problem.
  2. R

    Word to the wise.

    I did mine years ago but I cut and siliconed the screening to underneath the cowl cover so I could remove easier in the future cleanings. Dust still builds up over time but no heavy debris.
  3. R

    Introduction plus question

    Welcome to the forum. Which model # do you have + a picture of the set if you can.
  4. R

    BW1356 removal issue!

    If you have it, a spline drive wrench or socket is perfect for this. Don"t know if you have a Lowe's or Home Depot near you but they should have them or try Amazon. Good Luck!!
  5. R

    Vacuum Pump Oil?

    Didn't need to, chose to buy Motorcraft. I have been thru the remans, off brands, etc. Motorcraft always lasted longer than the others since 1992 on my trucks for me.
  6. R

    Ford Rotunda Injector Pressure Tester (incomplete)

    https://www.ebay.com/itm/FORD-ROTUNDA-OTC-TOOL-303-1135-303-1136-INJECTOR-PRESSURE-REGULATOR-VALVE-TESTER/174057448328?ssPageName=STRK:MEBIDX:IT&_trksid=p2060353.m1438.l2649 Not mine but thought someone may be looking for one. Shipping is quite high for me also.
  7. R

    Vacuum Pump Oil?

    My Motorcraft VP didn't come with such disclaimer. Guess they got it right the first time.
  8. R

    Mirrors

    Make sure you always have a rider on passenger side. Then you will have 'Red Neck" power folding mirrors to go with the 'Redneck Air'.:p:cheers:
  9. R

    Critical safety warning: Hot Shots fuel additives products

    I think the ammonia in the urine is what cuts down on the sting.
  10. R

    Critical safety warning: Hot Shots fuel additives products

    And if it's a jellyfish sting, piss on it. Or have someone else piss on it if you can't reach it.
  11. R

    Lift pump output olive or o-ring?

    The flare could also have a stress crack in it causing the light leak. Be sure and tighten that bolt with the rust around it on your alternator bracket at the water pump. It is loose if just slightly.
  12. R

    New glow plug issue

    When I used the older plugs, before my upgrade, I used pliers to tighten the grip on the female connection very lightly until it stayed on to my satisfaction. Too much and it will smash or break.
  13. R

    Help with search or the answer.

    Exactly, is what I used on both tanks/straps
  14. R

    Help with search or the answer.

    Any 2-3" wide strips of nylon, rubber, etc. strap can be used for the buffer between the 'fuel tank' and mounting straps. Up to you for the material to use.
  15. R

    New here, 94 E350 7.3 IDI school bus. Hoping to swap axles for increased MPG's

    Maybe this guy: http://www.nickpisca.com/diesel/
  16. R

    Upgrading to electric lift pump

    I would not run the Holley Red again. I went thru 2 of them & they have a very fine screen mesh inside that stopped up on both of them & burnt out the motors. I ran a prefilter with each of these but the screen was so fine that it still stopped up. I am running the Duralift at present & have...
  17. R

    '87 project- next round.

    Ford F1TZ-9A758-F - CABLE ASY - THROTTLE is your part number for the throttle cable. Use Motorcraft Only. Check Amazon, Google, etc. Should be around $70.
  18. R

    Is there anything else besides air intrusion ...

    Amazon delivers to your area? I did forget about the Hot Shot Secret Winter Anti-Gel:rolleyes:
  19. R

    Anybody familiar with the IH version of this engine?

    This is just one of the reasons I & others have moved to electric fuel pumps. The IHC 6.9s are basically the same with maybe different filters, IP, exhausting & accessories, etc Check valve will have to be added, not a factory supplied item.
  20. R

    Too much filtering?

    Change the hoses to after pump & see if it runs better. Probably having a hard time pulling thru the 2 micron filter.
  21. R

    Show us your IP wrench!

    I just ground the closed end on mine w/o the heated bend. Works fine.
  22. R

    Is there anything else besides air intrusion ...

    At -40*, moisture in your fuel & lines will create that problem. Get some Hot Shot Secret Extreme and double dose the tank(s).
  23. R

    I’ve got a tick...

    Hope so also
  24. R

    Rotunda 6.9 tool kit

    Same here. Noticed a lot of eBay stores separate the tools & lists them for RIDICULOUS prices & shipping. Blackhat used to have decent prices. Is where I bought a few tools way back.
  25. R

    Kent-Moore J33300-A complete kit NOS $415.00

    $690. Too rich for my wallet. 1st time poster to make a sale. -Flame Thr:number2

Latest posts

Forum statistics

Threads
92,996
Posts
1,155,953
Members
26,579
Latest member
truckonfire

Members online

Total: 1,324 (members: 1, guests: 1,323)

Share this page

Top