Search results

  1. pelky350

    Loss of power during acceleration

    Where did the pump come from and did you have it properly timed yet?
  2. pelky350

    To continue project or??

    The motivations there, the time is hard to come by these days. The truck started out under a tree covered in moss and full of mice, basically on its way to a scrap yard until I offered double scrapper value at 600$ as they thought it was hopeless but I drove it away with only needing to jump the...
  3. pelky350

    To continue project or??

    Okay so now it’s been raining a few days and this year my windshield is leaking everywhere, my visor is leaking and a old cb antenna mount is leaking dead center of my roof into my dome light and has now ruined my headliner, what sealant would be best to cover all these holes and leaks up before...
  4. pelky350

    To continue project or??

    Yeah that’s why I wouldn’t be able to sell it because I know a cab swap would bring the value up to 6x how it’s sitting, say if I were to decide to sell it “as is” even with all the current work I’d be lucky to see 1500$ in my area because we don’t have rust issues any rusted trucks with damage...
  5. pelky350

    To continue project or??

    Well the truck is basically what I need now is only be replacing it with another crew cab or a 4 door Bronco, almost traded for a crew cab turbo idi centurion bronco near perfect with a 5 speed 6 months ago but I just couldn’t let mine go. Currently my bronco is kept because it was my first...
  6. pelky350

    To continue project or??

    Basically it’s a piece of 1/4 inch holding the master cylinder into the cab with a long bolt to tighten it, also the dash internal supports are cracked in a couple spots and currently have no e brake because it went through the fire wall and the dash broke as a result the whole drivers corner is...
  7. pelky350

    To continue project or??

    I do have back up rig that needs a little work mainly alignment and tires but it’s reliability is kinda iffy I’ve had it for about 11 years and haven’t really driven it much since it was in a state of severe repairs needed but it’s not a idi and gets 5mpgs. I can still drive it in town but it...
  8. pelky350

    To continue project or??

    Up to now I have a ats 093 built by Russ with 60-1 mod, Cx racing intercooler instal, 90cc and stage 1’s from r and d, skyjacker 4 inch soft ride lift, new moog steering, limited slip rear end installed, rims and new Cooper discovery tires, replaced carpet and seats with newer ones in good...
  9. pelky350

    To continue project or??

    This contraption has been holing my clutch for 6 years now
  10. pelky350

    To continue project or??

    Alternative would be waiting tax time and buying another crew cab bricknose 5 speed idi truck and transferring most of my stuff like the lift and tires and aftermarket stuff onto it, the rust is in the cowl area, and basically down the firewall around all the important stuff like from e brake to...
  11. pelky350

    To continue project or??

    So I’ve had this truck for 7-8 years now it’s served it’s purpose as a 600$ 125xxx yard find, over the years I’ve put tons of time and parts at it from skyjacker lift kit to turbo from Russ and fuel system from r and d almost considered a build now I’ve replaced damn near everything or upgraded...
  12. pelky350

    Slow crank

    Half my starting and charging issues have been issues with the battery cables in some way. Started getting a slow crank and poor charging and this time my grounds were barley loose where the terminal clamps onto cable. A half turn on each and it turns over at almost idle speed again. Makes a...
  13. pelky350

    Intercooler

    That was a temporary piece I used to get by until the last pieces came in the mail, it’s all matching pipe now no flex hose
  14. pelky350

    Intercooler

    Yes
  15. pelky350

    Intercooler

    Using the Cx racing cooler that’s seen on here a lot with my 90cc pump, stage 1 injectors and a modified 093 turbo kit so basically the same set up as you. Works great very responsive and only lost like 1ish psi and everything over 10psi is solid power now not hot charge and falling on its face
  16. pelky350

    Backup lights

    Before huge modifying, they have some direct fit bright led bulbs that work great!
  17. pelky350

    So what did you do with your truck today?

    Went the the no be obs truck show today, saw a few idi’s actually! This one had a 088 ats with the coolest intake set up I’ve seen so far! Intake was inside a cowl inducted custom hood on a basically custom everything crew cab bull nose. Never did seen the owner around it hopefully the turbos...
  18. pelky350

    So what did you do with your truck today?

    Well discovered more rust than I hoped to find, gonna located a new cab at some point but for now just rust reformer and bed liner. Nothing really rust here so cabs of bricknose only cost like 100$ Usually. Just some surface rust here and there but this hole after brushing away loose stuff is...
  19. pelky350

    Head gaskets leak oil?

    Ip gear housing has been resealed, valve cover, fuel pump block off plate, water pump replaced and bolts sealed that pass into oil. Idk what one missing? Do any bolts for the front accessories pass into oil territory?
  20. pelky350

    Head gaskets leak oil?

    Thick black puddles on the ground, and doesn’t smell like diesel
  21. pelky350

    Head gaskets leak oil?

    Pictures of leak area, the gasket has since been sealed a second time where fuel pump was but it wasn’t the leak
  22. pelky350

    Head gaskets leak oil?

    Timing cover been removed and resealed also that didn’t fix it either. Can the valley pan really leak that much? It’s got the holes poked in it and a new turbo pedestal grommet from Russ
  23. pelky350

    Head gaskets leak oil?

    Is it common for a head gasket on these motors to leak oil externally like down the front of the block area? My oil leak isn’t valve cover, it’s not the fuel block of plate, not the water pump bolt, and it’s coming from the front of the motor and basically it appears to be in the area of the...
  24. pelky350

    So what did you do with your truck today?

    First new tires I’ve ever owned I bought today after owning the truck for around 90xxx miles now. Many people kept saying I should buy cooper tires so I went with it. 315/75/16 cooper stt pro mts
  25. pelky350

    So what did you do with your truck today?

    @Slicknik your gonna need some drop brackets for those leveling spacers or your gonna have a really bad alignment(like undriveable) you can already see the geometry is off with how the spring is sitting on the mount there and the bushing in radius arm is strained, just fair warning not saying...

Latest posts

Forum statistics

Threads
92,996
Posts
1,155,946
Members
26,578
Latest member
dogdanblue

Members online

Total: 1,423 (members: 7, guests: 1,416)

Share this page

Top