Search results

  1. u2slow

    Steering Stabilizer or Sway Bar with RFS?

    Factory tries to use as a low a caster setting as is manageable/repeatable without side-effects. 1-3 degrees is common. This small amount can be 'erased' with age - spring sag and bushing compression. When you start modifiying the suspension and/or different wheels, bigger tires, etc... may...
  2. u2slow

    Steering Stabilizer or Sway Bar with RFS?

    Sounds like death wobble. Whats your caster angle at? Is your pinion pointing more upward than before the RSK?
  3. u2slow

    A third hand for the brakes

    For the pipe thread, I use hydrocarbon-rated teflon tape, and/or a dope called Leak-Lock. I normally use both. This heel-toe thing.... not something I've mastered or desired to learn in my 20 years driving diesels. Set the park brake lightly and pull through it, then release. Your proposed...
  4. u2slow

    Plug block heater into "shore power"?

    More important is the contact surfaces and tension inside each plug, socket and receptacle in the chain. (Especially the one at the truck.) #16 is too small for 1000w at 150'; making enough heat to really highlight the former problem. Bad enough contact surfaces with #12 can yield the same...
  5. u2slow

    Plug block heater into "shore power"?

    Most factory block heaters are about 700 watts; which would draw around 6 amps.
  6. u2slow

    Who knows the size of the tread from the original fuel filter?

    Wix is generally a decent brand; that said, i'm not a brand loyalist. I usually look at the cheapest filters on rockauto, and then start googling for who actually makes them.
  7. u2slow

    Who knows the size of the tread from the original fuel filter?

    Using the wixfilters website, it says 1"-14tpi thread.
  8. u2slow

    Trans Temp too cold?

    Imho, ATF isn't thick enough to worry about pumping losses.
  9. u2slow

    Monroe gas Magnum

    Bilsteins, yellow magnums, and rancho 5000's have been a wash for me - no real difference. (Dodge with cummins and leaf-sprung dana 60 for reference.)
  10. u2slow

    slightly different zf5 swap question

    The 1410/1350 conversion joint used to be a pricey item. GMB now makes an affordable one 240-1435. If the driveshaft needs shortening, may be best to have a 1410 end yoke welded on instead.
  11. u2slow

    slightly different zf5 swap question

    I've drilled the upper web of the frame from below on other trucks. A long punch and long drill bit helps with the angle.
  12. u2slow

    slightly different zf5 swap question

    All I can say is for 94-95 era, the 2wd and 4wd crossmember look similar except for the dip on the driver side for where the front driveshaft is.
  13. u2slow

    Painting steel wheels

    Painting up wheels myself today too! 4 for the jeep and 2 for the dodge.
  14. u2slow

    Need brighter reverse lights....

    Aux lights for me too. Friggin dark around here at night.
  15. u2slow

    Another tire size question...

    255/85R16 is a limited selection, and less load capacity than the common 285/75R16. Here's my old pair of 285's I ran for the last 10 years... with a locker. Wore them about as evenly as possible by playing with the tire pressure. (On ford 16x7 wheels.)
  16. u2slow

    Exhaust

    Rockauto list a full kit, and all sections. If nothing else, see where else you can buy the part #'s. For me, the Y-pipe or downpipe is the key item. After that, its fairly easy to DIY custom-cobble the rest. Some OBS powerstroke pieces may have a larger diameter.
  17. u2slow

    Another tire size question...

    I liked the 285/75R16 size on my D250. Got me more top speed. Keep the tire pressure low for comfort, snow, ice, or rain. Jazz them up to full pressure for heavy loads (3750# capacity each).
  18. u2slow

    SRW to DRW

    Another trick you can do is run the wider dually axle with some heavy singles. 3400-4000# tires are plentiful when you go to 33's.
  19. u2slow

    SRW to DRW

    Rockauto also lists 3.5" wide shoes for dually.
  20. u2slow

    1993 VSS E4OD Question

    No, because the tone ring spins together with the ring gear; which is always turning at the 'right' speed for the ratio. 5mph off (high) is pretty normal from the factory. A slight bump in tire size will get your speedo closer.
  21. u2slow

    1993 VSS E4OD Question

    I recall dealing with a similar trans problem due to the axle vss (vehicle speed sensor) failure on a '97 F450 some 20 years ago. I cant say if 93 and 97 behave the same.
  22. u2slow

    another possible cab swap

    The pickup frame isnt that beefy.... so dont be using it like a 5ton.
  23. u2slow

    Need some knowledge

    I think its fine. Onto the third set now. Dont offroad enough really to bother airing down. Usually a lot of highway between adventure spots, and not setup for OBA.
  24. u2slow

    Need some knowledge

    Inflation pressure is up to you, and there's easily 1000# difference between various 'Load Range E' tires. I run load E tires on the jeep.... they only need 30-35# air for the road.
  25. u2slow

    F350 front driveline questions.

    You can shorten the F250 shaft and put the slip-joint end nearest the tcase. BTDT.

Latest posts

Forum statistics

Threads
92,997
Posts
1,155,937
Members
26,574
Latest member
sramasya

Members online

Total: 1,559 (members: 9, guests: 1,550)

Share this page

Top