I disconnected the fuel heater, went for a ride and no problems, can't believe something like that would cause this headache.
Now The only problem is why did it dump the trans fluid when he was driving in limp mode? But now it holds the fluids fine
Thank you all for your help
Sent from my...
Production date is 05/94 7.3 idi non turbo 2wd. Could be a stupid question, but Isnt that the same as a TCM or is there something different ?. Regardless I'll check that in the morning also
Sent from my SM-G930T using Tapatalk
The FIPL read 1.3 closed and 4.2 at WOT.i don't have a tool to read specifically. The fuses that blew read "K" glow plug controller fuel shutoff solenoid engine temp switch cold timing advance solenoid and cold idle solenoid. "U" reads fuel line heater electric transmission control and PM power...
Hello everyone, I am trying to help a friend out and get his truck back on the road. From what he told me one day the truck was fine, the next he's going down the road and it seems to struggle taking off from a light. Then it dumped all the transmission fluid onto the ground out of the...
I wish I had done my research first, I am so fed up with automatics I currently have two to deal with. For future reference I will keep that in mind though, thank you very much
I will pm you in a couple of days I have a couple of things to try first for free, plus my paycheck clears tomorrow anyway lol. Thank You for the offer I will be in contact
Alright I will purchase a gauge on friday.
Its kinda rough to admit being a mechanic, and not knowing the answers to these problems. problem I have is our shop doesn't touch transmissions we swap them or send the vehicle elsewhere so I have 0 experience. .. also having normal work (...
So if I pressure test it and the pressure is below spec (I Wil check all data tomorrow) I should bring it back to the shop?
This may be a stupid question but how do I check line pressure without a obd2 port and a scanner?
Well I will definately be installing a filter i was un aware of the importance. I also have to call the shop and get the specific details of what was done valve body wise and solenoid wise.. as far as I know the kit I provided (Trans star) was a gasket and clutch kit, a (dayco ) torque...
What could have gone wrong that you say it should be retaken apart and cleaned? And shouldn't the shop I had rebuild the transmission take care of it at this point?
At this point I wish I had put a zf5, but I steered away from that cause the clutch is a pain to push in from my experience. if...
That is the exact procedure I tried but I did not remember how large the range was for the voltage in the idle position. Every where I was looking said 1.1 to 1.2. I wanted to rule it out as a cause for slamming gears
I have not gotten a code reader at the moment, I will be getting that done the next slow day at work. The light does not blink, but when the button is pressed it turns over drive off and turns on the light as it should . Yes there was more metal than I would have liked to see on the magnet
I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.