Thanks I appreciate it.
@IDIBRONCO I got that saved for when I buy it this Friday. I was wanting to replace both bearings on both sides but I'm not sure which one it is. You wouldn't happen to know the part number for that because I keep finding tapered bearings and the even ring ones but I'm...
I've go grease all over my brakes and drum on the rear passenger.
It's a 94 F250 7.3 idi.
I went to autozone and they gave me this small seal but the last time I did my brakes a couple years ago I took the hub off and put the same seal back in because I didnt know I was supposed to replace...
I'm hoping so. I had no idea I had to time it once I put it in. People told me If i removed the gear cover I'd have to time it but i think itll be in good shape after this too.
Yeah I messaged @renjaminfrankln since he's in Raleigh NC and I'm just down the road in Wilmington NC. Hopefully he can help me out when I hear back.
I dont mind paying as long as I know I'm getting it right. I'm with you on getting someone on here to do it. I've had a tremendous amount of help...
Thanks for the input. I'll check it out and look into. There are some good deisel shops around town that I'll probably talk with.
Though the injectors are putting out 1600psi vs the 1900-2075 they are supposed to so I may end up changing them anyways because I would like everything to be to specs.
No I didnt know that I needed to do that because I was told if I took the cover over the gear that the IP bolts to then it would be out of timing.
I never removed it so I I thought it wouldn't effect the timing
I've always been mechanically inclined but never knew much about vehicles expect how to change basic parts.
I've had a crash course in what not to do and what to do to fix and diagnose a 7.3 idi.
I had never done any interior engine work till this and pulled the heads and changed them by hand...
Jeff at deisel parts told me they atomized correctly for the most part but a few of them kinda peed as he put it but after a few pumps of fuel they sprayed correctly but not at the correct pressure. I'm gonna swap out my injectors for theirs on friday and see what happens.
@stealth13777
Short...
My other thought was my engine bay caught fire a while back and the hose for the air filter was obviously warped some. Could the hose pictured allow a lack of air flow?
I appreciate the explanation, I understand the fuel to air ratio needs to be right and that's why I replaced the filter and thought maybe the injectors were putting out too much.
Air filter in a couple months old and I had the injectors pop tested at Deisel Parts of the Carolinas here in...
94 7.3 idi
When I'm pulling my ditch witch (about 5k lbs), my truck accelerates fine but once it gets into 2nd or 3rd gear once the rpms hits 1500 it's kinda stays there but slowly rises unless I give it more fuel but then a lot of black smoke comes out the exhaust.
It wont do it if I baby it...
Thanks guys. I've been looking for a place for the family and moving the past week all while working 8-12 hours 5 days a week.
The vacuum system was sealed. It was an airflow problem like some of yall suggested with the evaporator.
I cracked open the ac box and there was a think layer of what...
94 F250 IDI
My ac blows cold and it has different setting when you turn the knob but high barely feel like a light breeze when you are sitting back. I have to put my arms up to the vents just to get cool.
I bought a new blower motor which I think helped some but not by much if it did. It's got...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.