-
-
RWhat the push down one is good at is vibration isolation.......no rattling shifter handle.
-
RRondo replied to the thread Wiring Conundrum(s) II. : Brake Lights and Oil Pressure.If you are going to rebuild the harness, just unplug it and lay it on your garage floor. Keep the same plugs and splice in the wires you...
-
RRondo replied to the thread Borg Warner 1356 Transfer Case Rebuild.The push down is aluminum with a steel rod. Bad design. I can get a new one on Amazon for about $30. I’ll look for the pull over one. I...
-
RRondo replied to the thread Borg Warner 1356 Transfer Case Rebuild.Is that shifter the original? My 93 shifter i have to push it down and then pull back. I would love to have yours if it would work.
-
RRondo replied to the thread Install 7.3 and ZF5 Together or Separately?.That is one purty engine.
-
RRondo replied to the thread 2WD Super Duty front brakes to match 10.5 rear axle swap wheel pattern - easy or complicated?.Here is a template for drilling the new holes to use your own rims. https://cnafabrication.com/products/8x170-to-8x6-5-drill-template
-
RRondo replied to the thread How to set the timing on your 6.9 or 7.3 IDI and how to buy timing equipment..How did it work? Do you have pics?
-
RRondo replied to the thread 7.3 IDI with some issues.with 3.55 gears in 5th gear at 2000 rpm would be around 70 mph
-
RRondo replied to the thread '82 f150 project.You could send those pieces to India and they will weld it back together for ya. It will be good as new.
-
RRondo replied to the thread Install 7.3 and ZF5 Together or Separately?.Say a prayer before you stab the trans. My wife and I were able to stab it in less than 10 min. Almost like it was sucked to the engine.
-
RRondo replied to the thread How to set the timing on your 6.9 or 7.3 IDI and how to buy timing equipment..I also had thought about using the tack sensor as a trigger for timing the engine. Would need to make a short harness to connect to.
-
RRondo replied to the thread Rebuild My Stock Turbo Send to be Rebuilt, or Get Aftermarket Turbo?.If anyone is interested there is a guy here in Greeley, Co that has a new turbo he is selling for less than $500 I believe. If...
-
RRondo replied to the thread Timing 7.3.I adjusted it some, not done yet. I have increased 2-3 mpg and the engine is much quieter.
-
RRondo replied to the thread Timing 7.3.Thanks. I was able to move it barely. Does the - before the timing mean anything or can I just ignore it.
-
-
Loading…
-
Loading…
Latest posts
-
Question Re: Buying A Diesel Vs A Gas Truck
- Latest: ThinkingDiesel
-
-
-
-
