Luke_IDI
Latest activity Postings About
-
-
Luke_IDI replied to the thread Slow crank after possible overheat.I have a better update than the last. I found some videos over the weekend suggesting that injectors whose armature to poppet body... -
-
Luke_IDI replied to the thread Slow crank after possible overheat.Ok, I figured out why I am only seeing 50v. Looked in the manual for the scope and max input voltage is +/-5v. Using a 10:1 attenuator...
-
Luke_IDI replied to the thread Slow crank after possible overheat.I repeated the buzz test today. I wanted to make doubly sure that the injectors have enough voltage to fire. I unplugged the number 8...
-
Luke_IDI replied to the thread Slow crank after possible overheat.Truck has about 200,000 miles on it. I have zero clue about what maintenance was performed on the truck. Possibly not much, if the oil...
-
Luke_IDI replied to the thread Slow crank after possible overheat.I do not have a good injector, could possibly get one but that would require pulling one out of a friend’s van. I’d prefer not to have...
-
sounds like all 8 are buzzing and at the same intensity, with the valve covers off they should sound louder in my opinion, but that...
-
Luke_IDI replied to the thread Slow crank after possible overheat.The guy in this example says that with a buzz this quiet, the truck will not start cold at all—the block heater must be plugged in to...
-
Luke_IDI replied to the thread Slow crank after possible overheat.The injectors all sound very much alike, however I think they may be very quiet compared to a strong engine. I intended to do this test...
-
Luke_IDI replied to the thread Slow crank after possible overheat.I took a video of the injector buzz test today. This is with the valve covers off. It’s about 90 degrees today.
-
Luke_IDI replied to the thread Slow crank after possible overheat.I am checking the voltage at the injector connector, with the connector disconnected from the injector, positive probe on the white...
-
Luke_IDI replied to the thread Slow crank after possible overheat.I have not but that is first on my list of things to look at before looking at fuel supply further. The video you posted of where the...
-
Luke_IDI replied to the thread Slow crank after possible overheat.After an improved compression test, numbers are up around 300 psi. Not great, but should be able to fire I imagine. The search...
-
Even with that low compression (if accurate) you would still be seeing white smoke out the tailpipe while cranking if everything else is...
-
Luke_IDI replied to the thread Slow crank after possible overheat.Upon examining my gauge setup, the quick connect fitting was not fitting snugly and was leaking. Test to be repeated with new quick...
-
Luke_IDI replied to the thread Slow crank after possible overheat.I did another compression test today. Pulled all glow plugs (except for one which is bent over, not allowing the socket to slip onto it...
-
-
Loading…
-
Loading…
