Sorry for not posting in a while, but project had to be back burnered. The last of the parts showed up last week and we started doing some installs over the last few days and are hoping to have the engine and transmission in today. The trans ended up needing to be a zf6 since no one would do...
I have been burning a mineral oil that is as heavy as atf, straight in my fuel oil burner in my shop all winter. It wont start on its own so what I have been doing is about 20 min before I start working in the shop I use a propane bullet heater to heat the fuel supply line. After about 20 min...
:mad: So here is the rest of the pics, hopefully the others are showing up now As you can see on the floor under the truck I have the downpipe from the 2003 dodge and it looks like it will tie into the ford exhaust at a factory seam. Today I am deciding if I will be making my own mounts or...
These are pictures of the donor truck, a 2003 dodge 2500 hit in the side hard, I worked out a deal with Paul at Don Scharf automotive of Eagle River to take the whole thing to get everything I needed.
Over the last few weeks I have started this project and now I am at the point where I am at putting together and waiting for parts. I bought a truck with a dead 6.4 diesel and decided to go for the cummins swap. The truck was a theft recovery with some cut wires and missing items. Not knowing...
I have just started my project, I am going with the nv5600 on an 03 cummins in my 2008 f350, this seemed to be the cheepest route for me. I'll be starting a tread following the project with pics.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.