I had forgotten about my own thread. I got busy and put this project on the back burner. I did get the fuel pressure transducer hooked up to my diesel ranger, but the readings bounced all over the place. Could be a bad connection. Good to know about the sensors you are using. I'll have to...
Yes, right now it is just a simple 16 character 2 line LCD display, but i'd like to use a higher resolution touchscreen lcd later so it can have graphs and gauges
Woosh, that went over my head. Gotta lot more reading and learning to do. So looks like a variable reluctance sensor is similar...
Just started tinkering and though a good first project would be to get more instrumentation for my 91' e350 based RV.
First thing was fuel pressure. I was going to do pre and post filter to see when it needed to be changed, but i'll only have 5 inputs with this design so i think i'll just do...
Trying to replace it on my 1991 E350. Used this diagram to repin it, now I have no start. Only thing odd I noticed was pin 6 on the old connector labeled Trans range sensor. It is a white with red stripe. I went ahead and put to pin 7 on the new one. I've seen some people say it doesn't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.