I am putting a DTA466 in my 4700 with a side by side aftercooler. The 466 has the top inlet intake and I need a bottom inlet intake. IH can't look up an intake by "style". Anyone able to help me with a casting number, part number, or VIN of a truck with the proper intake? Or, anyone with a...
This one will be afordable! I am going to have to rob a few bolt ons to make the 466 swap but it can certainly be had for less than a $1000. From what the folks at Shiver Diesel tell me the 360 is a stronger motor than the Cummins. 3500 RPM isn't out of the question and they will live all day...
Does anyone know if a DT 360 manual flywheel will work on a DT 466? I assume if there are no balance "bulges" and the bolt pattern is the same then it is OK.
In the process of swapping a 360 to a 466 and discovered the intake on the 360 points down and on the 466 points up. My aftercooler...
Dropped the pan it is the number 1 and number 2 liners. However, it looks like it may just be O-rings. At any rate, I have a DT 466 on the shop floor and as soon as I rebuild the engine crane JACK I'll finish removing the 360 and install the 466.
I have a 190HP DTA 360 in a '93 4700 I will be selling. It is being replaced by a 466. The motor has water in the oil. Pulled the pan and discovered number one and two cylinders leaking from the sleeve O-rings. Has 300,000 miles on it and was well taken care of. Price is $1500. Complete...
Nevrenufhp, drop me an email. I have a DTA 466 on the way to "tune up" for my 4700. I just drug the truck in the shop today. Plan to drop the pan on the 360 tomorrow after church to see if it is a liner or O-ring leaking. The motor will be for sale most any day. If it isn't a liner and...
I have a DTA 360 (93' 190HP). It has water in the oil. Haven't dug in yet to see if it is simple or if it needs liners and pistons. I have a 466 located to replace it. Neighbor is interested in the 360. What kind of value does a complete "rebuildable" motor have?
Thanks,
I saw a IH 4700 wrecker today with a chrome grill. Looked like vent louver. Anyone know where to purchase such? I know chrome won't make it go faster but it will look cooler on the way!
Thanks,
I just purchased a "junk" 92 4700 with a DTA 360 and 6 + 1 tranny. I mostly wanted it for parts to turn my S 1800 4 door into a "newer" model truck with a DTA 466 instead of the huge gas moster. The motor has water in the oil so more than likely has a liner rotted through. I actually purchased...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.