here is a better res version of that video. go to settings and select 1080 and expand to full screen and you will see that bushing in the upper half split and flex on the splines. this truck just turned 142k miles so they def don't last forever.
over the last 2 years, i have adjusted the steering gear box 5 times. the truck had the best steering out of any ford diesel i had owned to date. i purchased the truck with 80k miles on it. the previous owner bought it to tow his fifthwheel only and i use it the same or 90% of the time. with...
edit: my truck is an e99 drw with 3.73 gears and a manual zf6. just to be clear, this turbo is best suited for an auto trans imo. i never saw over 1200* egts, not even on a 96* ambient temp day, while pulling my toyhauler. i try not to travel on those hot days but un avoidable sometimes. this...
we have seen far to many aftermarket remote start and alarm systems shut vehicles down or create large power draws. when i say shut vehicles down, i mean just shuts the engine off while they are driving. people love those aftermarket remote start,alarm systems but they have a short life...
also, if your going to use oil additives then use rev x or archoil. both work great but archoil will mix with atf where rev x says not to. so once a year pour a cap full of the arch oil into your power steering res and that really free's up worn or weak pumps. i and several others ( obs and...
congrats on your purchase. i too drive an e99 zf6 quad cab drw 4x4. i'm sure you have checked your alt to make sure it's working properly. if that alternator isn't keeping up or borderline then that will effect the injectors. your clutch issue......the e99's used a diff throw out arm then late...
21k miles on this bw sxe 366/73 with .91 t4 divided exh housing. exh housing was thermal coated by whomever full force diesel uses. shaft play feels good. the p/n info tag is in the pictures. $650 obo, yes, i am willing to ship it if the buyer pays for the shipping. any questions 402, ...641...
have you considered an adrenaline hpop? i swapped to one 6 years ago and it def out performs the stock one. when i purchased mine it was because it was only $50 more then the terminator rebuild at the time. the adrenaline comes on sooner and holds better pressure then stock. here is a pic of a...
i know this is an older post, but, how did that work out for you?
i am swapping down to a sxe 363/68 with a .91 from my current sxe366/73 with .91. i pull a toyhauler 10500 lbs loaded and never exceed 2400 rpms while towing and dip to 1800 at 65 mph. the sxe 366/73 efficency range is 1950/ 2000...
the e99 sd had a .84 exh with wg but they are not a t4. in fact none of the factory .84 housings were t4. the obs and e99 sd's are basically the same turbo except the exh housing. so the garrett 38r turned out not to be a good turbo by todays standards. i have no idea what stock turbos were gt...
i had two injectors that lost the oil o ring in my e99. sent 4 qts of oil into my fuel system on a 5 hr drive pulling a fifthwheel. went to restart and it cranked longer than normal as in twice as long. 4 qts is a lot of oil loss as stated above, it's going somewhere and needs to be found before...
if your not seeing any boost at 65 mph ( flat ground or on a hill) and your turbo spins free w/no end play then i would check the waste gate and make sure it's not stuck wide open. better make sure your ebpv isn't partially closed as well. you might want to check your fuel psi to make sure you...
i have an e99 drw. i run kyb monomax front and rear. so they do make for a stiffer empty ride but are perfect while towing a 34' fifthwheel toyhauler. i would not put them on the front and will drop to the excel g's in the front and stick with monomax in the rear. the excel g's are a middle...
so i watched craigslist until i found an older snap on scanner that couldn't be updated past 2005. it's no good to current mechanics but for those of us with sd's or obs they would awsome. i picked it up for $100 with all the keys, card and adaptors in the carry case. so this snap on unit...
i actually had the throw out arm crack on my zf6. it added vibration at lower rpms. pedal felt soft and with 81k miles i decided to just put a better clutch in it as all i do is pull. repair shop recommended a puck clutch. i wish i would've went with a twin disc clutch as that puck clutch sucks...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.