Cubey's latest activity
-
I like these clamps because they do their job equal and you can tighten them more. Extra nut may not be necessary. But since the bolt is... -
Cubey replied to the thread Best radiator hose clamp?.The 85 RV with the original 85 hose (in early 2019 when it finally sprang a leak) had the factory clamps. I saved them but I'm not sure...
-
-
Fleetguard
-
Cubey replied to the thread Best radiator hose clamp?.It does for me with a 1/4" drive 5/16 or 11mm deep socket. You could shim it with washers or a bushing between the clamp's T and the...
-
Pesky worm gear clamp on the lower radiator hose at the radiator kept working loose. I happened to be at Harbor Freight and saw these...
-
-
Cubey replied to the thread Is it my alternator?.1G type of alternator? If so, check the two wire plastic connector to see if it has come out/loose. It has a plastic spring on the...
-
My old mans truck has the same issue with two different engines. I'm sure its something dumb like a bad ground or something but I ended...
-
Factory gauge is not a real gsuge
-
Cubey replied to the thread C6 overheating mysterious cause.9.5 sounds about right with a deep pan and coolers.
-
Cubey replied to the thread C6 overheating mysterious cause.I got a Four Seasons one via Walmart recently and it seems to work ok. Do you have the transmission connected to the radiator cooler...
-
C6 transmissions puking fluid out is not a common problem with those. Something is wrong somewhere. While they are fuel hogs, they are...
-
Cubey replied to the thread U-joint warning chime.When I found it bad that morning, just before getting on the highway towards a bigger city in Colorado, from Laramie WY and having the...
-
For the last couple months I started having a clank sound from somewhere under the truck whenever I shift between forward and reverse...
-
Cubey replied to the thread U-joint warning chime.The carrier bearing on the f250 i had went bad with almost no warning. I heard clunking and checked it, found bad play. continued on...
-
When you get the trans warmed up, put it in park with it idling and pull the dipstick. Wipe it off and then put it in again and when...
