BlindAmbition's latest activity
-
BlindAmbition replied to the thread parallel turbos.Found the thread. I imagine you could compensate for higher fuel pressure by advancing or retarding the IP timing as needed. Just be... -
BlindAmbition replied to the thread parallel turbos.10 psi is too high and changes the timing of the pump I believe. My R&D pump came calibrated for 7psi. There is a rather large and...
-
BlindAmbition replied to the thread parallel turbos.Might need to run a vent tube to each intake tube, you're only scavenging from half your cylinders otherwise. Most things I read say to...
-
BlindAmbition replied to the thread parallel turbos.I'd move your crankcase vent to one or both of your intake tubes instead of the end of the air filter. There should be more suction...
-
BlindAmbition replied to the thread '86 Extended cab project thread.Oil line is plumbed. 1/8 npt on the block to 4an fitting and then a 24" line. Oil block on turbo has two feeds, second feed is 4an as...
-
BlindAmbition replied to the thread Help on timing with a snap on mt1480.This thread has info that should help steer you in the right direction...
-
BlindAmbition replied to the thread '86 Extended cab project thread.Mounted a smaller reservoir to be the fill spot for the system. Will likely need to lift it when filling to get the air bubbles out...
-
-
BlindAmbition replied to the thread '86 Extended cab project thread.Worked on the intercooler reservoir today. It's an old 3.4 gallon propane tank from a VW Westfalia van, was going to use it for my air...
-
-
BlindAmbition replied to the thread '86 Extended cab project thread.Figured out the intake piping, took way longer than I thought. Ended up taking a piece of aluminum, bending it by hand to make a mockup...
-
-
BlindAmbition replied to the thread Valve Stem Seals.I installed positive seals on all of the valves, posted on the IDI FB group with the same question, Justin at IDI Performance said it's...
-
BlindAmbition replied to the thread WTB: US Gear Dual Range Housing (Ford 4x4).Also make sure your unit is indeed an overdrive. Mark the input and output, then spin by hand and count revolutions. If it is 1:1 then...
-
BlindAmbition replied to the thread '86 Extended cab project thread.Figuring out arrangement for the fuel setup, coolant/windshield bottle, and oil bypass, looks like it will all fit. Moving the CAT fuel...
-
-
BlindAmbition replied to the thread '86 Extended cab project thread.Spent a lot of time trying to figure out this intake hose business. Have more adapters on order, may have to redo the intercooler...
-
-
BlindAmbition replied to the thread '86 Extended cab project thread.@The_Josh_Bear Here is the link to the filter. It is an AEM Dryflow unit https://www.amazon.com/gp/product/B001DX7F5G
-
BlindAmbition replied to the thread advancing timing.Have you searched this forum at all? This topic has been covered dozens and dozens of times. Basically loosen the three nuts on the...
