BeastMaster
Latest activity Postings About
-
-
BeastMaster replied to the thread Tach cutting in and out.The problem is likely the tach sensor. You replaced the throttle position sensor and vehicle spéed sensor. Did you replace the tach... -
BeastMaster reacted to IDIBRONCO's post in the thread New 6.9 IDI - Deciding if worth resurrecting or not with
Like.
This is set up for the 7.3 style glow plugs with the bullet connector ends. -
BeastMaster replied to the thread Volt regulator.I believe that ground text on that regulator connection is to show you what terminal to touch to ground with a test wire. This bypasses...
-
Have you checked for a drain on the batteries when the key is off? I had that problem with a transmission relay that was stuck in the on...
-
BeastMaster replied to the thread New 3g alternator--High voltage and then low voltage, bad regulator?.You have the battery in there. It should hard clamp the voltage above 15 volts. The current should go through the roof! ( Hundreds of...
-
BeastMaster replied to the thread New 6.9 IDI - Deciding if worth resurrecting or not.As for the schematics of the glow plug circuit, search this site for them. Glow plug problems are a very frequent discussion here. My...
-
-
Loading…
-
Loading…
