You must be registered for see images attach
http://www.etrailer.com/Brake-Controller/Hopkins/20262.html
Hopkins Brake Controller - 20262
Brake Control Wiring Adapter for Pre-Wired 1992-93 Ford Full Size Pickups and Bronco
The plug on the vehicle is located under the dash near the center console on most vehicles. If no power is going to the conector (use a circuit tester to check), additional wiring will be needed to be run to the port. Use the ETBC7 if a 7-way trailer connector is also needed.
The brake control wiring adapter is used to simplify the electric brake controller installation. The 4 wires on the adapter are butt-connected to the 4 wires coming out of the electric brake controller. The harness is then plugged in to a port under the dash. In most cases, the factory will have run the rest of the wires to the 7-way trailer connector in the back of the vehicle.
Hopkins # 47695
Replaces 18262