david85
Full Access Member
I've been chasing my tail of and on for the last few weeks trying to locate a solid spacer kit for the sterling 10.25" rear end in my truck. So far I've found ONE website that carries a kit for them, but when I enquired, they gave me the run around, referred me to a distributor that was 'authorized' to sell to canadians who then never got back to me after saying they would send me a paypal invoice..........
http://ratech.stores.yahoo.net/sopibespwish.html
Ok, so I read some anecdotal evidence that ford used the same crush sleeve on everything from the 7.5" all the way up to the 10.25" rear end. Some other sources indicate that the 8.8, 9, and 10.25 share the same spacer, and therefore, a solid spacer shim kits listed for the semi-floaters *should* work on the diffy in my truck.
Help.......
Can I get a kit that is listed for an 8.8 or 9 rear end and expect it to work for me?
....or if not, where can I find a solid spacer shim kit that will work?
I even sent off an Email to Yukon to ask for a distributor which went unanswered (even when I enquired about 3.08s some one got back to me...). I guess nobody wants my money.
http://ratech.stores.yahoo.net/sopibespwish.html
Ok, so I read some anecdotal evidence that ford used the same crush sleeve on everything from the 7.5" all the way up to the 10.25" rear end. Some other sources indicate that the 8.8, 9, and 10.25 share the same spacer, and therefore, a solid spacer shim kits listed for the semi-floaters *should* work on the diffy in my truck.
Help.......
Can I get a kit that is listed for an 8.8 or 9 rear end and expect it to work for me?
....or if not, where can I find a solid spacer shim kit that will work?
I even sent off an Email to Yukon to ask for a distributor which went unanswered (even when I enquired about 3.08s some one got back to me...). I guess nobody wants my money.