MarX740
Registered User
Finally warmed up enough to do things again so I got around to pulling all the GP's and putting a boroscope down them.
Scope is 5.4mm dia and wouldn't go into the actual cylinder in all but #7. Thinking theres something up with that as all the GP holes should be the same size no?
These are the captures I was able to get.
1
2
3
4
5
(See next post)
Scope is 5.4mm dia and wouldn't go into the actual cylinder in all but #7. Thinking theres something up with that as all the GP holes should be the same size no?
These are the captures I was able to get.
1
You must be registered for see images attach
2
You must be registered for see images attach
3
You must be registered for see images attach
4
You must be registered for see images attach
5
You must be registered for see images attach
(See next post)