putting a homebrew turbo kit on my N/A 91 idi. need a hand with a couple mods
1) relocate GP solenoid. I want to do manual control on them, do I just run the (i think) blue signal wire from the solenoid to a grounded switch inside the cab?
2) CDR. Best way to block the hole in the back of the intake where it used to suck clean air from? Then punch a hole in the VC for it to drain thru, and grab fresh air anywhere past the air filter? Wont this pressurize the crankccase when boosting?
1) relocate GP solenoid. I want to do manual control on them, do I just run the (i think) blue signal wire from the solenoid to a grounded switch inside the cab?
2) CDR. Best way to block the hole in the back of the intake where it used to suck clean air from? Then punch a hole in the VC for it to drain thru, and grab fresh air anywhere past the air filter? Wont this pressurize the crankccase when boosting?