DesertBen44
Full Access Member
One of my lines them (which was difficult to loosen I might add) Never got tightened. I spun and spun and spun and it just never seemed tight when I reinstalled it. The injector threads looked fine, and I tightened it with what is basically a stubby wrench, never applying anywhere near the torque I did to the others.
Is there anything i can wrap the threads with that can stand up to injector pump pulses and pressures? Its a long shot but just curious. I will also be removing these lines again in a week or 2 to install my new injectors, so it does not have to be permanent.
Thanks in advance!
Is there anything i can wrap the threads with that can stand up to injector pump pulses and pressures? Its a long shot but just curious. I will also be removing these lines again in a week or 2 to install my new injectors, so it does not have to be permanent.
Thanks in advance!