So I found out why my truck wont start its because the fuel sending unit has a hole in it. I was wondering what sending unit can I use I don't want to pay $400 for a new one. I spent so much money on this truck and haven't even drove it yet. The line has two holes in it can I just jb weld it or can I use a gas fuel sending unit please help.
fuel sending unit has a broken hard line
- Thread starter bdemutis
- Start date
79jasper
Chickenhawk
If there's room, you could use some copper pipe and a compression fitting.
Or even slip a tight fitting hose over it and clamp it.
Can you post a pic with the location of the hole?
Sent from my SM-G900R4 using Tapatalk
Or even slip a tight fitting hose over it and clamp it.
Can you post a pic with the location of the hole?
Sent from my SM-G900R4 using Tapatalk
There is no room to do that it formed at the base of the pipe where it goes into the metal cap.
Clean it good, then JB Weld.
