AcIdBuRn02ZTS
Full Access Member
Hey guys...
Well I just got around to installing my banks cdr adapter and figured while I had the timing cover off, I could put the pin at 12:00 and bump the fuel up.
Lined everything up... new 5/32 allen wrench and a 5/32 wrench on that... couldn't get the screw to budge. Felt like something was going to break so I quit.
Just how tight are these screws as far as adjusting them? It shouldn't be maxed out as I only see 1kF at full tilt.
I couldn't get it to move either direction. Any tips?
Well I just got around to installing my banks cdr adapter and figured while I had the timing cover off, I could put the pin at 12:00 and bump the fuel up.
Lined everything up... new 5/32 allen wrench and a 5/32 wrench on that... couldn't get the screw to budge. Felt like something was going to break so I quit.
Just how tight are these screws as far as adjusting them? It shouldn't be maxed out as I only see 1kF at full tilt.
I couldn't get it to move either direction. Any tips?