So.... I was all set to clean up my rear drive shaft and throw a fresh set of joints and carrier bearing. As I was pulling the circlips something hit the floor. And then I realize it's a balancing weight.
It literally rusted off. [emoji35]
So I got all the joints out but I really have second thoughts.
So the slip yokes aren't too bad. The end yokes are not terrible except the 1 but the tubes are pretty roached.
Opinion: retube or full replacement or used?
A cursory search has not turned up a used option.
Any recommendations for a shop around MD, southern PA, northern VA? I'm not brave enough to just do it myself.
At this point I'm pretty set on not just running it. I've got too much into this thing to put a questionable component in now.
Thanks for your thoughts.
You must be registered for see images attach
It literally rusted off. [emoji35]
So I got all the joints out but I really have second thoughts.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
So the slip yokes aren't too bad. The end yokes are not terrible except the 1 but the tubes are pretty roached.
Opinion: retube or full replacement or used?
A cursory search has not turned up a used option.
Any recommendations for a shop around MD, southern PA, northern VA? I'm not brave enough to just do it myself.
At this point I'm pretty set on not just running it. I've got too much into this thing to put a questionable component in now.
Thanks for your thoughts.