Chevyboy_0
Mr.SunnyDisposition
I machined mine out of 6061 AL.I started out with a piece of 5" tubing with 1/4" walls, The base was turned out to 5.250" and I welded a cap on the top and turned it to clean it up all nice and pretty like Then I milled a hole in the side and welded a piece of 4" tubing in the side. I made it just tall enough to clear the Inj Lines. Then I built an extension tube out of 304 SS to run right down to where the old intake went in the Core Support.
http://rides.webshots.com/photo/2913891380105187216yJJoil
http://rides.webshots.com/photo/2918342320105187216MTNbED
http://rides.webshots.com/photo/2913891380105187216yJJoil
http://rides.webshots.com/photo/2918342320105187216MTNbED