Nope. The IDI turbo was available for 2.5 years. I have one from a 1995 truck. I bought it out of a wrecked truck with a little over 300K on it.
Ford knows the truck exists even if the aftermarket doesn't.
I have that engine...
I have one.
7.3 IDI Turbo from a 1995. They were in like 3% of the Ford F-series that year. 1994 had that option too.
I think it has plenty of power. I have gotten a best MPG of 15. 14 might be average in my crew cab.
I actually have a rebuilt tranny for that...
Yep.
I've not looked upon Cardone as being a high quality remanufacturer.
My old boss even got a rebuilt HEI distributor from NAPA once that had electrical tape wrapped around part of the pickup and PRESTO it was new! Didn't last long. The NAPA guy said "well, I guess that one got by...
Hi Trisha,
Basically we have two separate descriptions now, one being that it was a no-start and the second being that the starter would "grind" and not turn crank the engine. I think your mechanic may be a bit challenged with the repair by your description of the problem.
If your engine is...
I got some pix taken. I'll dig them out.
Actually I gave it relatively short crank cycles with breaks although many of them. I got it running and then over several hours I started it a few more times and it fired up instantly. I went to fire it again and click-burning wire smell. Very...
1997 body, 1994 IDI wiring.
I believe the switch worked well before conversion so I will chase wires first.
I guess I should consult wiring diagrams for wire colors...?
All the other lights in that corner work as well as the other filament of the bulb. I suppose I should have provided this...
Good suggestions.
The first thing I did was check the timing on my serendipity. It was good so I checked the air in the back tire.
Really I did start with checking bulb (brand new but checked anyway) and socket to which there is no voltage. I didn't start chasing wires or anything.
Against all advice and logic and out of desperation I finally used starting fluid, just a shot.
It fired up instantly, ran great, continued to work and started up every time after that as well.
The starter seems to have crapped out unfortunately but I will disassemble it in the morning and...
Hah! "Tanks for setting me straight"
Both lines are 5/16" - delivery and return.
It was only drawing vacuum, no flow. Like it was stopped up or something. Strangely this problem has evaporated. After switching the tanks back and forth a bit it works fine...
I can pull fuel through with...
I have a thread started in the IDI section of this site. I started this one here because time is short for this project now and I really need some help.
I got everything done and had it running when nothing was hooked up and now I can't get it started. LOTS more details in the IDI section...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.