Search results
-
7.3 idi e40d no 1st gear
If I added a led indicator light to the 1st gear solenoid wires with the truck in drive or first the light should come on without driving the truck correct. Might try this before I pull the accumulator body off. Just to verify it's calling for 1st.- Danny B
- Post #8
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3 idi e40d no 1st gear
Even though the pack clicked does that mean it's good? I will check the accumulator next. Thanks again for the advice and direction to go. I'm about ready to plant flowers around this truck.- Danny B
- Post #6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3 idi e40d no 1st gear
Update replaced the BARO sensor today and still takes off in 3rd gear. Drove it down the road came home and checked codes got a code 62 (transmission 4/3 circuit fault. Any ideas would be greatly appreciated. Thanks- Danny B
- Post #4
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3 idi e40d no 1st gear
Ok, thanks I will order a new one and give it a try. My next thought is the solenoid pack went bad from sitting- Danny B
- Post #3
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3 idi e40d no 1st gear
Truck takes of in 3rd gear, has o/d and torque converter lock up. Can manually get 2nd gear, replaced vss,tps ecm,psom,mlps, temp sensor, tach sensor. Set mlps correct, set tps 1.1 to 4.2 wot. Trans is new rebuild, Speedo is correct with GPS, tack works correct. Tested complete trans wire...- Danny B
- Thread
- Replies: 9
- Forum: 6.9L IH & 7.3L IDI Diesels
