Search results

  1. O

    Driver's door panel availability

    Go to www.lmctruck.com but they are VERY pricey.
  2. O

    Anybody got a spare tach sensor?

    Take one of your "toasted" ones and stick a short piece of a paper clip into the sensor where the wire goes in, strip the plastic off the wire and untwist the strands, then wrap the strands back around the piece of p-clip. Solder or heat shrink the connection. :dunno OkieGringo
  3. O

    Running out of steam @ 3k

    Here is a "Mod" ya might wanna try... High Speed Filler Necks for $40.00 compliments of Jimmie Fishes All we’re trying to do is give air that’s inside the tank a better way out, as incoming fuel displaces it. The actual process is easier to do. All you do is remove & gut your filler neck...
  4. O

    Running out of steam @ 3k

    I haven't been to the "Easter Jeep Safari" since 1990. The "Lions Back" was awesome. I did all the 4+ trails and a few 3s. I even tried the "Sand Hill Climb", that is absolutely the softest/finest sand that I've ever seen. I've heard that the "tree-huggers" have gotten most of the good trails...
  5. O

    Idle speed. temperature and brakes

    To check the connections to the IP, here's what you need to do. Turn on key to 'run' position. Check the main wire that comes from the loom to the IP (injection pump), does it have juice. The wire runs to the FSS (fuel shutoff switch) connector first, then to one side of the Cold Engine...
  6. O

    Anybody got a spare tach sensor?

    I might have a "toasted" one laying around:D . Would that be in your budget? Scrape some of that "Gold " paint off yer truck and trade it at Stealership:rotflmao . Sorry, it just seems that with all the goodies you have on yer truck that you could afford "Stealership" prices. Hell, you don't...
  7. O

    Aftermarket cruise?

    Zigg, i just use an old lever off of an old lawnmowercookoo . I think I saw a cruise control that will work on these engines at JC Whitney.;Sweet Okiegringo
  8. O

    transfer case ?

    The leaking IP could be due to a bad rubber gasket behind the 'fuel screw turn-up port(triangualr plate)'. I'd hate to see ya spend big bucks on an IP for a bad gasket. cookoo OkieGringo
  9. O

    Threw another belt

    I can't seem to get the photos from www.webshots.com to go into my "signature". The original photos were on a CD but someone has overwritten them-cuss . The ones on my laptop are gone when it went 'belly-up'-cuss -cuss -cuss . Friggin' "Murphy Factor". Do I need "permission" to write up a "Tech...
  10. O

    Threw another belt

    Here ya go, try this and let me know if it works.
  11. O

    Joined the Oilburner nation!! 1ST diesel!!

    As far as I know....Hypermax is the only company that make a turbo setup specifically for the vans and they're pretty darn reasonably priced. cookoo OkieGringo
  12. O

    transfer case ?

    I doubt that your truck will have the "plug & play" harness, but you can "mickey mouse" a switch in somewhere. You'd be MUCH better off just shipping that transfer to me;Sweet . cookoo OkieGringo
  13. O

    Threw another belt

    Ok, then get a BIG ASS crescent w(r)ench:backoff , and use the 1" knob on top of the alternator to tighten the crap outta the belt:dunno . cookoo Okiegringo
  14. O

    Threw another belt

    Alt Belt Idler Pulley See the link in my "Signature" for photo. Autozone part # 45954 and get a bolt 3/8"-16 x 1-1/2" hex flanged cap screw. The pulley cannot be larger than 4" OD. Just remove the bolt from water pump and replace it with a 3/8"-16 x 1-1/2" bolt. Find a bolt with threads all...
  15. O

    E4ODOA!!!

    A/C fire might have fried the FIPL or wires to it. Try replacing it first. check the Wires on the Tach sensor also and the TECLA relay. Good luck, OkieGringo
  16. O

    I need a starter

    The photo isn't a gear reduction unit but the description says OSGR. good price, but I like being able to pull up to Autozone and tell 'em to whip out a new one, install it in their lot(if necessary), and be on my way. My mitsu is still spinning fast after 3 yrs, so far. good luck with your...
  17. O

    tank selector valve?

    My fuel valve only returns to the rear tank. I need a new one but the one on my '87 only has 3-ports/3 hoses? W.T.F., over? If anyone has a 3-port, please let me known how much you want for it. Thanks. OkieGringo
  18. O

    coolant questions

    Fleet Charge is what I'm now using. I got it at O'reilley's but had to ask for it because they keep it back in the stock shelves for some reason. Prestone also makes Pre-Charged A/F, comes in Black bottle with purple field. Pre-charged A/F has been "standardized" and it purple in color, NOT...
  19. O

    E4OD performance parts

    Cowboy, here is some info for ya. Full-size trucks first received the huge E4OD (Electronic 4 speed OverDrive) transmission in 1989. Internally, it is essentially a C-6 with overdrive added to the front (such as the A4LD is to the C-3) and an EEC controlled valve body. If it becomes...
  20. O

    Happy Birthday Travis

    Travis, I hope you had a great birthday today;Sweet . Just how friggin' old are you these days? cookoo OkieGringo
  21. O

    Fuel problem found!!!

    Here's a link... http://www.dzljim.com/Ford/tank.htm 33 gal Bronco fuel tank. cookoo OkieGringo
  22. O

    Priming fuel system

    Before I change the fuel filter, I warm up the engine, and I also have an electric pump so it has not been a problem. I turn on the e-pump and hold the schrader valve open until the filter fills and starts squirting fuel, then fire it up again. cookoo Okiegringo
  23. O

    how bad did I hurt it.

    Doug, the 2nd table does not work for Lo Range with the Baumann TCS. You'd usually be in 1st with shift lever in 1st or rev anyway. Okiegringo
  24. O

    over voltage???

    Go back and read my reply post again, and the one just above this one. Just because it is new, it does NOT mean it works right!!!! It me 3 tries to get a good one. OkieGringo
  25. O

    over voltage???

    Hot voltage regulator? I hate to sound like a broken record, but,:yell: REPLACE THAT DAMN REGULATOR!!!! cookoo OkieGringo

Latest posts

Forum statistics

Threads
91,320
Posts
1,130,296
Members
24,129
Latest member
morerunner

Members online

Total: 561 (members: 6, guests: 555)

Share this page

Top