Search results

  1. S

    rust proofing primer

    Planning to paint my frame and flatbed cause they are rusty. What is a good product to use to seal in the rust?
  2. S

    Chewed up teeth on flywheel

    I have been having problems with my starter not engaging. I replaced it today with a new one. When I took off the old one I could see some of the teeth on the flywheel are chewed up pretty bad. The new starter acts the same way, just grinds against the gear on the flywheel. So I put a 15/16...
  3. S

    Brake rotor question

    The caliper on the front of my truck have been sticking lately. It gets so bad that I can smell the pads burning. Yesterday I was going to replace both calipers and pads but when I pulled the tire noticed a large crack in the rotor. I have been looking for rotors online and have found...
  4. S

    Glow plug problem? or worse?

    I changed my glow plugs recently and one of the old ones was full of dark black oil. Is that a sign of a major problem?
  5. S

    I need a starter

    Is this a good deal on a starter? The add says this is a Mitsubishi. Any pros or cons when compared to a nippon? http://cgi.ebay.com/ebaymotors/Ford-Diesel-Truck-6-9-7-3-Starter-F-High-Torque-17037R_W0QQcmdZViewItemQQcategoryZ33576QQihZ003QQitemZ130130883003QQrdZ1 Thanks, Dewey
  6. S

    F350 with a cummins

    Looks like a good project truck for 6 grand http://cgi.ebay.com/ebaymotors/Ford-F-350-06152E1015_W0QQcmdZViewItemQQcategoryZ39416QQihZ013QQitemZ230145974012QQrdZ1
  7. S

    Hard starting when hot...Or not?

    My truck always starts great when it is cold. But, for about the last month it sometimes takes a lot of grinding to get it to start once it is warm. I mean grind and grind until the batteries are almost dead, say a prayer, cuss, wait a while, and then it finally fires up. So I searched though...
  8. S

    Rear disc brake conversion

    I got tired of trying to keep the rear drum brakes adjusted on my truck. It seems if not done every month or two they just would not do the job. Last week I replaced the drum setup with a disc brake conversion kit from the Streetrod Manufacturing Co. http://www.tsmmfg.com/2670.htm This is...
  9. S

    pump timing?

    I think that my pump timing is somewhat retarded. I've been trying to buy a snap-on or rotunda timing meter off of e-bay, but haven't got one yet. So in the meantime I'm going try to advance the timing a hair at a time, just to see if there is any improvement. So can anyone tell me which bolts...
  10. S

    Very interesting bed for sale on Ebay

    http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=220100922848#description Read the description on this guy's sale. I asked him the question about pictures of wife and girlfriend. I'm sure a few others here can come up with some good questions for him also. Dewey.
  11. S

    Oversize rear fuel tank

    Here's a good deal on a tank for someone down south. There should be some way to shoehorn this in . http://cgi.ebay.com/ebaymotors/FORD-99-06-42-Gal-Aft-Fuel-Tank-Auxiliary-F250-F350_W0QQitemZ160034389997QQihZ006QQcategoryZ33556QQrdZ1QQcmdZViewItem
  12. S

    glow plug question

    I'm putting in glow plugs today and the two front plugs on the passenger side don't want to thread in to the head as far as all the other ones did. I can still see a few threads sticking out where-as the rest seemed to go tight to the head. Is this normal or a problem. I'm using anti-seize on...
  13. S

    fuel injector code question

    I purchased some injectors and return kit from HERE and received them yesterday. They are Delphis marked code BB. Is this the correct code for the engine in my sig? I also picked up a set of glow plugs from autozone. Is there any advantage/disadvantage to installing the plugs and injectors all...
  14. S

    Might be buying a bed

    Anyone near Uniontown, PA 15401 ? I am looking at a utility bed there and need some help. How well would the bed from a super-duty fit on a 91 f-350? cookoo
  15. S

    My truck is farting

    My truck starts good in the morning and seems to run just fine going down the road. My problem happens after driving around for awhile and then shutting it off. When I first start it back up, it spits & sputters and coughs & hacks for about 5 seconds. Yesterday while going through the drive-thru...
  16. S

    Bronco 33 gallon tank

    I need to install a rear tank on my truck. I want to go with a bigger tank. I am going to be using it to play around with alternative fuels. I found a good deal HERE This one has the Large Gauge Hole 3-5/8". Is this the same size hole that we use on diesel trucks? Do I need a sending...
  17. S

    Parts on Ebay

    parts Has anyone ever dealt with this seller? It looks like he is parting out a couple of trucks.
  18. S

    I've been looking for one of these

    But 3 grand is a little much. 8 foot box
  19. S

    reverse shackle kit

    reverse shackle Anyone install one of these before? Is this a good deal?
  20. S

    torque converter lock-up mod

    I read about a mod to manually lock up the torque converter on my E4OD POS, but I can't find the link now. Can anyone help me? I am turning 2000 RPM at 55 MPH. When I first got the truck, I would have been turning about 1500. If I push harder on the accelerator it feels like the converter...
  21. S

    f-350 supercab

    I'm looking to buy another 4x4 f-350 diesel, but I need a supercab or crewcab, something to carry the little butts around in. I want the 97 (98?) or older bodystyle. My question is did Ford build one with a short-box and what years are available. The only one's that I,ve seen around have the...

Latest posts

Forum statistics

Threads
91,324
Posts
1,130,347
Members
24,130
Latest member
JFMac

Members online

Total: 558 (members: 8, guests: 550)

Share this page

Top