Deal of the week..
A 1985 6.9 106,000 miles when pulled last year(been sitting on a stand)
and a zf 5spd 4x4 from an 89 f-350. Has the pto on the side but the shaft is cut. Doesnt effect the tranny. I have the slave cylinder, flywheel and bolts etc for the tranny. the motor is complete from...
I have a 89 D-60 4x4 front axle from a dually truck.. Axle was already cut out and is on the ground.. Nothing else with it(springs etc) does have the
dually spacers still on it.
I bought it thinking i could use it in my 78 4x4.. No luck sold the truck
$500
located in 19401 in PA
I have an 84 6.9 Diesel, its complete including the complete wiring harness from the truck under the hood.
Ran well when pulled, was going to be used in another projectm but sold the project.
Only thing i'm missing is the valve cover bolts on one side, took them off to check how clean it...
I have a Zf 5spd from an 89 F-350 4x4 Worked well when removed.
Did have a pto on it and pto shft is cut but still connected to trans. I have trans, flywheel and Slave cylinder etc..
Make me a good offer and its yours.. Located in PA 19401
Anybody in the PA, NJ, DE area have a diesel front crossmember for sale or parting out a truck?
This is the crossmember the motor is bolted to.
Let me know what you have
and a price
Group
i can pick up a PSD from a 96 Van, for my 78 4x4 Crewcab Swap,
and was wondering if the Van Psd was different then the truck??
Can it be used? I also want to use a Zf-5spd behind it.. I'll assume the crank will accept a pilot bearing?
Also anyone know any articles for a PSD swap..
Group
went to look at another IDI motor, and it has a blown out exhaust manifold, that went and coooked the fuel pump on the block..
anyone ever hear of this??
What causes the manifold to blowout? Castiron usually handles the heat well
Group
just picked up an 89 zf 5spd for my 78 f-250 4x4 6.9 swap
Only thing i didnt get with the tranny was the inspection cover on the bottom of the bellhousing and the adapter plate between the tranny and block. Is the adapter all the same?? I have one from the original 4spd still on the...
Group
i'm ready to swap the 6.9 into my 78 F-250 CC 4x4, and wondering about the Trans.. WIll the NP 435 hold up behind the 6.9? It was bolted to a 460 previously and the rears have 4.10's running 37" tires. The 6.9 i have already has a bellhousing /stick setup on it and the clutch fits on the...
Group
anyone that can help me with a swap to a 6.9 into a 78 f-250 crew 4x4???
Or a 7.3 if i have to and a 5spd ;)
whats all that is needed?? Wiring shouldnt be that hard for a diesel, its not a PSD.. anyone that can help fire away
joe
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.