Search results

  1. M

    Truck's stumbling on cold start, thinking it might be a fuel pump issue.

    This issue started about a month ago, where it would catch but take a few seconds of throttle to the floor to get up to normal fast idle speed on a cold start. Now it's at the point where this afternoon the truck won't start. I believe the traditional "air intrusion" symptoms are it fires off...
  2. M

    Engine Running Cold

    My engine was running colder than normal, but erratically. The temp gauge would move around more than normal ranging from the N to the hash mark by cold. It used to sit at N once up to temperature and only go above that if climbing a long grade under load. At any rate I replaced the thermostat...
  3. M

    Rebuilt Injection Pumps and Injectors Sourcing

    I know the big four rebuilders mentioned around here are R&D, Moose, Russ, and Classic Diesel Designs. I've been hoping to pick up a 80CC pump and a set of injectors from R&D for a month or so now but haven't had any luck catching any in stock. R&D is relatively close by so the whole support a...
  4. M

    7.3 IDI Cranking but not catching.

    I drove the truck Saturday and it started and drove just fine, filled up the diesel tank on the way home. Sunday I went to start it, I warmed the glow plugs until they began cycling, and I cranked it but it didn't catch at all. Gave it a couple cycles. Normally, if its cold (freezing or lower)...
  5. M

    Crank no start with ignition key, with ignition key on and jumping the starter relay truck starts

    So my '91 is being a little funky. I resurrected an old thread looking for advice when I misdiagnosed the issue and will include that original post down below. Here is what is going on. If I turn the key, let the glow plugs warm, and then crank it just cranks and cranks and doesn't catch at all...
  6. M

    Probably bad DMF?

    Gentleman, here's what has been done and what the symptoms are, I'm hoping y'all can help me solidify what this issue may be before I go off half cocked and have a new flywheel put in and the tranny replaced (one bad synchro, one on the way out) in the process. I have a '91 F250 with a 7.3 IDI...
  7. M

    Finally got around to testing, and then replacing the glow plugs.. 4 stuck.

    I know this topic has been hit quite a few times in the past. I've pulled 4 plugs so far, the rest seem to be grinding pretty good as I spin them once screwed out but I can't move them up and down at all. Not sure if that is swollen plugs or carbon. The other 4 plugs seemed fine in that respect...
  8. M

    Banks Turbo Install - Turbo and Pressure Chamber Not Lining Up

    I have a '91 F250 7.3 with a ZF5, I'm in the process of installing a Banks Wastegated Turbo Kit on it. I purchased the kit from Banks. Except for the continuing frustration where I have found over a dozen missing bolts, nuts, and washers thus far in the Banks provided kit (sealed fastener bag)...

Forum statistics

Threads
92,996
Posts
1,155,931
Members
26,574
Latest member
sramasya

Members online

No members online now.
Top