Search results

  1. Spun4Fun

    E4od problems.

    After i gone thru my E4OD top to bottom front to back early this year it drove like a dream , One morning my O/D started flashing and my RPM's were acting up and did not let go to the point were it was going to effect my Tranny so i ordered NOS tech sensor . Problem fixed no bouncy tach or O/D...
  2. Spun4Fun

    Slow Cranking IDi

    Yaah might be take a 2nd look , I have seen things fail out of the box before
  3. Spun4Fun

    Slow Cranking IDi

    riotwarrior db electric seems to be priced well but couldn't find the 4kw only one seems available is the original Mitsubishi https://www.dbelectrical.com/p-1345-new-starter-ford-e-f-truck-van-69-73diesel-high-torque-85-9.aspx
  4. Spun4Fun

    Slow Cranking IDi

    My previous post show i replaced both of them with brand new 850 CCA
  5. Spun4Fun

    Slow Cranking IDi

    I am planing to pull it out some times today and post a pic along it's Part # . I am assuming it's the Original OEM starter and the PO never changed it since every thing on this truck is Original
  6. Spun4Fun

    Slow Cranking IDi

    2 Brand new Interstate 850 CCAMP batteries . I did not change the cable posts but the connection looks solid . no swelling or deformation in the Red or black cable, All ground connection are clean at the block for both negative and by the frame Brand new ZF glow plugs over 2 month...
  7. Spun4Fun

    Slow Cranking IDi

    79jasper Where did you get your starter rebuild kit from ? Thank you I just came across this one http://aspwholesale.com/index.php?act=viewCat&catId=381&page=all But which one is our starter calling for
  8. Spun4Fun

    Slow Cranking IDi

    Hey guys am thinking of rebuilding my Mitsubishi Starter rather than buy re man one . I am trying to save some $$ as other projects came up and life expenses adding up . Can any one please tell me where to get a re build kit from that would be greatly appreciated. One more Q that is not...
  9. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    On top of the Pump there is 2 electrical connectors one of them responsible to run the pump, Make sure they are connected securely am not sure if there is fuse related to the IP or Not but it seems like you not getting fuel pass the filter . Was the fuel filter under the hood full to the...
  10. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    what am saying it seems like fuel related since it ran good , then it turn over with no firing
  11. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    before you pull any tanks , Simply check if you have fuel going to the injectors / filter just my .2 c
  12. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    What that has to do with the Price of rice in china Bill . he is cranking but not getting kabooooom clink clink clink , It ran before and ran in the am before it cut off ( his post #12 ) . which leads me to believe it's fuel related unless he is not getting power to crank that's a...
  13. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    Nah carbuerator are Pain in the AZZ , These trucks are simple you just need to get enough diesel soot under your finger nails
  14. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    What break did you find .. ? If you crack one of the nuts on top of the injectors are you seeing fuel coming out ..? If no fuel there back track to the filter , Loosen the filter and see if it's full if not you might have a bad lift pump
  15. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    My guess with the voltage gauge would be either a faulty gauge or bad signal but i could be wrong, Specially if you know for fact that you charging system output is correct , I am sure other members could pin point it
  16. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    Bad Tach sensor will trip and pretty much set an O/D light causing the transmission to shift strange or worse case not shift at all . Pretty much it reports the signal to the transmission module. Also like the other member said , Go under the truck by the Passenger side and make sure that...
  17. Spun4Fun

    My tach isnt working neither is voltage gauge, The trans is acting up eod as well

    http://www.oilburners.net/forums/showthread.php?73482-7-3-IDi-Tachometer-sensor
  18. Spun4Fun

    Slow Cranking IDi

    uhhh .. Its sold WTF
  19. Spun4Fun

    Slow Cranking IDi

    Hey guys would you trust buying this starter , Money is tight right now and few other cars in my house hold needs Maint & parts it seems like when it rain it poor http://www.ebay.com/itm/291503882276?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
  20. Spun4Fun

    Slow Cranking IDi

    My Local NAPA have Nippondenso Starter or the OEM Mitsu replacement .. What is the main difference between the 2 ? From what OLDBULL saying that is normal AMP draw for our Trucks so that leaves me to think i do not need a Starter ..! :dunno
  21. Spun4Fun

    Slow Cranking IDi

    took the truck to Auto zone to see what is that tester can tell me about how much AMP my starter draw or what not , The 1st test show the starter draw 620AMP the 2nd one show 592 AMp . According to the Guy that is so much AMP for a starter to draw , In his opinion he declare it bad . What...
  22. Spun4Fun

    Slow Cranking IDi

    Well voltage droop testing on both the - and + passed reading between .4-.3 DCV when i turn the key to start . So i asked my son to start it after to the WTS light cycle . As i was watching and waiting i couldn't help it but to notice the GP relay was making a strange buzzing sound and some...
  23. Spun4Fun

    Slow Cranking IDi

    Zero corrosion that i can see without stripping the jacket of the big wires but they passed resistance test and non of them are swollen , However i am going to do the voltage droop testing on both the - and +
  24. Spun4Fun

    Slow Cranking IDi

    Every thing been cleaned real well and tighten pretty snug
  25. Spun4Fun

    Slow Cranking IDi

    One thing i need to check that just came across my mind is Voltage Drop Testing from the battery post to the starter for both the - & + leads

Latest posts

Forum statistics

Threads
93,001
Posts
1,155,996
Members
26,589
Latest member
tke395

Members online

Total: 788 (members: 1, guests: 787)

Share this page

Top