I always have terrible luck with parts quality alternators are no different,
Make sure your yellow wire is clean and tight that’s what tells the regulator what to do so if it’s loose/ bad connection it will get readings all over the place
https://www.garysgaragemahal.com/gauges1.html
found a proper guide on changing the odometer reading.
https://www.garysgaragemahal.com/tachometers.html
and general info on tachs
Just scored a factory bullnose tach cluster today 90$
Been searching for over a year now could only find one for 200$+
I’ll be painting the needles,red line, and yellow line I’ve never seen anyone do it so I figured ittl make a fun little thread for any interested
Just jammed the tach in and...
My buddy bought a return set off diesellogic that i tried to installed the cap fit was like throwing a hot dog down a hallway and leaked within 50 miles
while I'm not the biggest fan of this system but if you install them right with properly fitting parts i haven't had any issues in 2 years its as simple as making sure your return lines aren't too long causing them to stress the o ring and making sure you get a nice click when putting them on...
Probably 150k
Off topic but can you take a picture your tach up close just bought one and I’m going to
Paint the yellow and red line and yours is in decent shape for color
defiantly can do damage if you clutches are worn, you just need to pull the pan and filter off and what comes out comes out, measure what you took out for guideline to put back in
i always do a quart of lucas in every auto fluid change i do
notch the inlet of the filter cheap insurance
Not sure about brick and aero comparability but as Nero says the connectors are just chillin behind the kick panel, I had to put a manual door on my truck for a while and swapping it to electric was a piece of cake the bolt holes are the same just simply swap the regulator and crank out for the...
Just bought a tach cluster so I figure might aswell redo the tach sensor sheathing
I think I’ve done a pretty good job with wiring on this rig especially how 50% of the wiring is not stock
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.