Search results
-
D
Ignition Actuator Alignment
1986 F250 6.9 idi XLT Tilt Steering Hey ya’ll! My truck would no long start with the key. I replaced the wishbone that commonly breaks and replaced the turn signal actuator while i was in the column. I have been trying for hours to get my ignition actuator to align with the rack gear...- Dummy99
- Thread
- Replies: 4
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
ATS Turbo Oil Feed Leak
The oil feed on my 093 ats turbo I just finished installing is leaking oil out of the fittings on the hard line. The orings? in the fittings are very stuck. Is there a way to replace the seals or am I better off ordering a braided line? Thanks!- Dummy99
- Thread
- Replies: 23
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
Starter Solenoid 6.9idi Wiring Question
I am getting the last of the wiring on my truck put back together. What does this red wire coming off of the hot side of the starter solenoid go to? I have a 3 post starter solenoid. Wire is outlined with purple. Thanks!- Dummy99
- Thread
- Replies: 10
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
1986 F250 4x4 Swap - T-Case Shifter Hole
Hey y’all! I have a 1986 F250 that originally was a 2wd with a C6 auto. Some time ago I swapped a 4wd ZF-5 into it and and am in the process of finishing a frame swap for 4wd. I was wonder if anyone had measurements for the t-case shifter hole in the trans tunnel cover. I have the BW-1356...- Dummy99
- Thread
- 1986 4x4 swap zf-5
- Replies: 12
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
Zf5 Grinding
1986 F250 6.9idi A couple weeks ago I finished swapping my 2wd C6 for a 4x4 zf5 with the Borg Warner 1356. Donor truck had a south bend solid flywheel in it so I had the flywheel resurfaced and bought new south bend clutch, pressure plate, and throw out bearing. I replaced the syncros and...- Dummy99
- Thread
- Replies: 7
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
Camber Adjustment
Is some able to educate me on how alignment is done on these twin I beam axles with kingpins, I am having an issue with camber. The shop I took my truck to for an alignment says I have about +1 driver and +1.7 passenger (Their printer was supposedly broken so can't say for sure)however they've...- Dummy99
- Thread
- Replies: 35
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
Spittin White Smoke on Highway
1986 6.9 idi c6 trans I was headed down the highway going 65 until I saw billowing white smoke from the tailpipe. Truck was running rough and I immediately pulled off. Found something that looks like coolant on the ground. Proceeded to look down the air intake and it’s filled with coolant. Is...- Dummy99
- Thread
- Replies: 2
- Forum: 911 Diesel Down!
-
D
Interior lights and radio
1986 f250 6.9 idi single cab 2wd Hey y’all My cab lights and radio just up and lost power. Is I pulled the fuses and they all looked good but I can’t find a fuse diagram for it. Anyone have an idea for what could’ve happened? Sent from my iPhone using Tapatalk- Dummy99
- Thread
- Replies: 6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
Air Intrusion
Hey ya'll! It's been a few weeks but my issues have returned. Symptoms: (Just asking to confirm that this is air intrusion) I now have the truck in the garage and am pulling out the return lines and will install typ4's return line kit. I will also be getting 5 feet of 3/8ths fuel line and...- Dummy99
- Thread
- Replies: 2
- Forum: 6.9L IH & 7.3L IDI Diesels
-
D
Oil Pressure Gauge and ticking
Hey ya'll I've been lurking here for some time and I finally bought a 1986 F250. I've had the truck for a few weeks now and have been lovin it but two things have shown up. First, my oil pressure gauge reads low at idle but immediately jumps back to normal with any additional rpms. Truck still...- Dummy99
- Thread
- Replies: 18
- Forum: 6.9L IH & 7.3L IDI Diesels
